Fuel Filters
Fuel Pumps
Oldsmobile Cutlass Supreme

How do you access the fuel pump on a 1993 Oldsmobile cutlass supreme?

91011

Top Answer
User Avatar
Wiki User
Answered
2010-10-24 03:09:57
2010-10-24 03:09:57

inside gas tank,remove tank.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


"What is the firing order on an 1994 Oldsmobile cutlass supreme 3.4L engine?"


I HAVE A 1992 OLDS CUTLASS SUPREME JUST BE FOR it warm up it cuts off


Buy a Chiltons or Haynes manual and read it



Which model 1993 Oldsmobile and which flasher relay? Turn signal or hazard relay?Cutlass Supreme and it's the flasher relay


To fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2-door, remove the trim and access the mounting screws. Remove the nuts and disconnect the linkage rod by flipping the small clip and sliding the rod out of the handle. Reverse procedure for installation.




Stick the starter in the cutlass supreme.


You can find the 1993 Oldsmobile Cutlass block heater on the right hand side of the engine block. You can follow the block heater cord directly to the block heater.


what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6


It takes a special gauge to install the crank sensor. It can be rented from some parts stores.


The engine is fuel injected and idle is controlled by the ECM (computer) on 1993 cars


The 1993 Oldsmobile Cutlass Sierra thermostat is located on the front of the engine. You can follow the water supply line from the radiator to the thermostat housing.


price on replaceing ball joint 1993 cutlass supreme


take inside door panel off or loose enough to get to the 3 nuts that hold the mirror on.


i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?


After you remove top plate, hoses,trans lines, fan & shroud it should lift straight up.


There wasn't an option for a 4.3 in the 1993 cutlass supreme. You had the 3.1 and the 3.4 dohc as your options.



Yes, if the blower isn't working. If it turns out to be the fuse, and it blows again, you probably have a bad blower motor.


If the hazard control is in the dash--may be part of that module - it is in the newer GM vehicles If not it should be in or close to the fuse block


You can remove the fuse; however, it also controls the horn and radio. It is the 3rd row from the left and the 3rd fuse down.



how do you replace the headlight switch on a 1993 cutlas ceria*



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.