Locate the Break fuid reservoir
remove the lid
Fill with the fluid type identified in you manual to the line on the side -
Do not go over the line.
replace the lid
where do I add brake fluid to my Honda accord 92
To refill the brake fluid for a 1992 Acura, you need to remove the cap on the brake fluid reservoir. Add fluid until the dipstick measures full, or the line on the reservoir that says 'full' is touched by the brake fluid.
You add fluid the same place you check the fluid.
Brake fluid is in resevior on master cylinder. Look in engine compartment on firewall just in front of steering wheel. The brake booster is a large round drum and the master cylinder is attached to it. Use a flat screwdriver to slide the two clips off the flat lid. remove lid to add fluid as needed, but remember brake fluid will remove paint, so be careful.
Check the level of brake fluid in the master cylinder reservoir. If it is low that will illuminate the brake light also. If it is low on brake fluid it's time to have the brakes serviced.
Refer its wners manual or Simply, take it to the mechanic.
your clutch run's of off your brake fluid the place where you put your brake fluid in to fill it up there is a hose the run's from it. it goes to your clutch master cylinder
Dot 3Dot 3
fluid level low
there isn't clutch oil only transmission and engine oil
Probably a rotted out brake line sprung a leak, check the brake fluid reservoir.
you have to open the hatch, take all the plastic interior apart, just to get to your bulbs. its a pain.