Chevy Lumina
Ford F-250
Chevy Camaro Z28

How do you add coolant to a 2001 Chevy Lumina?

232425

Top Answer
User Avatar
Wiki User
2007-11-14 23:10:12
2007-11-14 23:10:12

If starting from empty pull the top radiator hose off the engine and fill the radiator until coolant starts to flow from the engine hose bib. replace and tighten hose. Fill the overflow tank with coolant. Locate the vent on the coolant hose bib (brass fitting), start the engine and allow coolant flow to purge the air from the system. When coolant flows steadily close the vent. Re-top up the overflow tank.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to add coolant to 1991 lumina?

User Avatar

Generally via. the coolant reservoir holding tank in the engine compartment. Just look for the white plastic tank with the lid showing radiator info.

User Avatar

no cap, just the coolant tank, add to this to add coolant../

User Avatar

NO it does not. You must add coolant in the big plastic clear jug on the passenger side fender.

User Avatar

if u have not done any work on the a\c before and u need to "add coolant" then u more than likely have leak somewhere wich needs to addressed first.

User Avatar

How much antifreeze does a 1998 chevy mabilu ls take

User Avatar

To change the coolant in an AU Ford Falcon 2001 model, open the radiator drain plug and add warm tap water once all coolant stops coming out. Again drain the radiator and add the coolant.

User Avatar

cold engine only remove the radiator cap and pour then fill to cold line on the reservoir

User Avatar

Where is the radiator cap on a 2001 Volvo s40?

User Avatar

the low pressure{or suction}line is located under the air filter housing

User Avatar

it will say low coolant and it means you need to add a mix of 50/50 coolant and water to the overflow.

User Avatar

i have the same car. ya just go ahead and add it to your radiator while running

User Avatar

no cap, there is only a cap on over flow coolant tank. to add coolant add to tank make sure it is at the right level when cold.

User Avatar

The coolant goes into the overflow bottle on the passenger side, fill it cold and do not over fill.

User Avatar

It doesn't have one. If you wanna add more coolant you will have to do it with from your reservoir.

User Avatar

allways add to the overflow bottle not the radiator it is usaly labled on the cap. PS its under the hood

User Avatar

Monitor your engine temperature and your coolant levels. Chances are you need to add more coolant to the car.

User Avatar

Add the coolant into the coolant reservoir. Be sure the engine is cool when you remove the cap off the reservoir.

User Avatar

Behind the engine is a dipstick labeled transmission fluid. Pull the stick out and pour in the tranny fluid with a funnel

User Avatar

The overflow resavour is where you add coolant

User Avatar

Faceing the car.On the left hand side you have a engine coolant reservoir bottle.If you are just going to add some coolant.Make sure when adding coolant it is a 50/50 mixture.Do not add engine coolant when the engine is hot. The cooling system in your vehicle is filled with Ford Extended Life Coolant F6AZ-19544-AA.DO NOT MIX WITH A GREEN-COLORED COOLANT.

User Avatar

Make sure the coolant level is ok, add fluid if needed, that should make the light to go out if light still on you will probably have a bad coolant level switch and will meed to replace it


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.