0
fast way? take off cap on suction side of the compressor,large hose hook up hose from freon can start engine turn on a/c with high fan on open the valve on can and fill until the bubbles go away on the receiver dryer located on pass side fender well.
While the engine is running turn off valve and remove the hose from service valve.
replace cap on valve job done.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why does a 1987 Chrysler fifth avenue have 3 catalytic converters?
It doesn't
How much did a 1987 Chrysler Fifth Avenue cost new?
Around $15,000
What kind of gas does a 1987 Chrysler fifth avenue take?
87 Octane unleaded
What kind of bulbs for rear signal light on a 1987 Chrysler fifth avenue?
1187 bulb
Where is the voltage regulator located on a 1987 Chrysler fifth avenue?
passenger side fire wall
Where is the amplifier in a 1987 Chrysler fifth avenue?
It's located in the trunk under the carpet of the back seat
How much is a 1987 Chrysler fifth avenue worth?
Depends on overall condition, mileage, options, etc...
Where can you find a picture of the distributor firing order for a 1987 Chrysler fifth avenue?
Try Auto Zone.com
What is the fuel tank size in gallons of a 1987 Chrysler Fifth Avenue with a V8 318 engine?
18 Gallons
What is the Blue book value of 1987 Chrysler fifth avenue?
Depends on overall condition, mileage, options, etc...
Where is the ignition module on a 1987 Chrysler fifth avenue?
There is no ignition module on a 1987 5th ave. The spark control computer is on the air cleaner with a vacuum line hooked to it.
What causes 1987 Chrysler fifth avenue drivetrain clunk?
U-joints. Get a hammer and a punch. Replace both ends of the drive shaft.
