Raise and support the front of the truck. Place a drain pan underneath and remove the transmission pan bolts from front and sides and loosen rear bolts. Carefully pry front of pan down to allow partial drain. Remove pan and filter, clean gasket mounting surfaces. Replace gasket, filter and pan, tightening bolts to eight foot pounds. Refill Transmission Fluid to fill marks on dipstick.
Assuming this is an automatic transmission, you would add ATF through the transmission dip stick tube.
Add transmission fluid until the dipstick reads full.
Assuming this is an automatic transmission, you can add ATF through the transmission dipstick tube. The dipstick itself will tell you what type of fluid to add.
You would add ATF through the dipstick tube.
Fluid is added through the transmission dipstick.
When the level gets to the add mark. Usually the add mark will require 1 pint of fluid. Never ever overfill the transmission with fluid. Check the level according to instructions in your owners manual. If you have to add fluid, then you have a leak.
dipstick tube
transmission fluid is uaually added through the trans dipstick tube.
Through the automatic transmission fluid level dipstick , near the firewall
if its an automatic you put it in through the filler tube or trans dipstick tube if manual on the side of the transmission
Through the automatic transmission dipstick tube. Add proper fluid with engine running, transmission in park, until the dipstick reads full cold. Type of fluid is marked on the dipstick.
from the transmission dipstick use some adaptor so you can drop your oild inside.
Yes... where the dipstick is. You take a funnel and add enough fluid to fill it up to the proper level. Do this while the engine is running and the transmission is in Park.