To adjust the clutch in a 1997 Isuzu pickup, first, ensure the vehicle is on a level surface and the engine is off. Locate the clutch master cylinder, which is usually near the firewall; check the fluid level and top it off if necessary. Then, adjust the clutch pedal free play by loosening the lock nut on the pushrod and turning the pushrod to achieve about 1-2 inches of free play at the pedal before resistance is felt. Finally, tighten the lock nut and test the clutch operation before driving.
It is a hydrolic clutch does not need adjusting
It probably has a hydraulic clutch so you will have to bleed the air out of it.
YOU CAN"T, There is NO adjustment, Time to replace the clutch
10mm nut above the clutch pedal
You dont. It is hydraulic. Cannot be adjusted.
how do you replace hydraulic line on a 1997 s-10
You can adjust the clutch pedal free play but not the clutch itself.
The fan clutch on a 1997 S10 has a bolt on the center of the front. Remove the bolt while holding the clutch still. There is a special tool to grab the clutch fan from the rear to hold it while removing the bolt.
take the cap off and roll another rodeo under it
I have been told that the 1997 SL2 has no clutch adjustment. It is self adjusting until it can't adjust further, then it needs replacing. This info comes from a trusted mechanic.
Usually there are 4 nuts holding the clutch and fan on to the water pump shaft. Just pull the nuts, remove the fan clutch and replace it.
adjust the clutch