Where is the low idle fuel mixture adjustment on a 2007 LT 1046 cub cadet riding mower model # 13AP11CH710
I have a 2007 cub cadet LT 1046 riding mower. I wish to adjust the low idle fuel mixture, but cant find the adjustment screw. Could you tell me where, and would I have to take off any other components off to get to it? the mower has a Kohler Courage 23 HP Model SV 720S engine. Thanks- Butch.
The fuel mixture is controlled by the computer and is not adjustable.
torque specs air fuel mixture screw on a yz125 2003
adjust the two fuel screws all the way in and adjust a half turn out until you get it right
The CBR 100 RR is a fuel injected bike, you can not adjust the air fuel mixture, however if you change the exhaust you can sometimes get an aftermarket programmer that will re-map the fuel and timing. Hope this helps!
To adjust the air and fuel mixture on a Nissan Terano, you typically need to access the carburetor or the fuel injection system, depending on the model year. For carbureted models, you can adjust the mixture screws located on the carburetor. If it's a fuel-injected model, you might need to use an OBD-II scanner to check the air-fuel ratio and potentially adjust the fuel pressure regulator or replace the air filter. Always refer to the vehicle’s service manual for specific procedures and settings.
They are to adjust the air/fuel mixture.
Fuel mixture can not be adjusted it is computer controled.You can adjust the idle by removing the cover where throttle cable attaches to the throttle body and turning adjustment screw
need to know how to make adgustment
i think is yes
Start at 1 1/2 turns from seat and adjust until you get the best idle
Buy a programmer