answersLogoWhite

0

need to know how to make adgustment

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you adjust your air fuel mixture on a new carburetor?

Start at 1 1/2 turns from seat and adjust until you get the best idle


How do you adjust air and fuel mixture of Nissan Terano?

To adjust the air and fuel mixture on a Nissan Terano, you typically need to access the carburetor or the fuel injection system, depending on the model year. For carbureted models, you can adjust the mixture screws located on the carburetor. If it's a fuel-injected model, you might need to use an OBD-II scanner to check the air-fuel ratio and potentially adjust the fuel pressure regulator or replace the air filter. Always refer to the vehicle’s service manual for specific procedures and settings.


What type of carburetor is on a 2007 Harley Davidson Fatboy?

If I am not mistaken, all 2007 Harley Davidson's were fuel injected and would not have a carburetor.


How do you adjust the air and fuel mixture on Mitsubishi Galant 2000 mikuni carburetor?

Start at 1 1/2 turns from seat and adjust for best idle


Why would a 305 tbi run lean?

Too much air to fuel mixture with your carburetor, adjust the carb settings to allow for more fuel to enter the chambers.


How do you adjust a 1978 Fiat Spider Werber carburetor?

there is two mixture screw one for air the otherone for fuel u can ajust the carb from there


How to adjust air fuel ratio holley 4160?

To adjust the air-fuel ratio on a Holley 4160 carburetor, first, ensure the engine is at operating temperature. Then, use a vacuum gauge or an air-fuel ratio meter to monitor performance. Adjust the idle mixture screws, located on the sides of the carburetor, by turning them clockwise to lean the mixture and counterclockwise to enrich it, aiming for the highest vacuum reading or optimal air-fuel ratio. For more precise tuning, consider adjusting the main jets if needed, but this typically requires removing the carburetor.


Where is the air fuel mixture screw at on aVTX 1300 C?

The air fuel mixture screw on a VTX 1300 C is typically located on the underside of the carburetor. It can vary in placement depending on the specific model year, but you may need to remove the carburetor to access it. Make sure to consult your bike's manual or a professional before attempting to adjust the air fuel mixture.


How do i adjust the carburetor on a baja motorsports 90?

To adjust the carburetor on a Baja Motorsports 90, start by locating the adjustment screws on the carburetor body. Typically, there are two screws: one for the idle speed and another for the air-fuel mixture. To adjust the idle speed, turn the screw clockwise to increase the RPMs or counterclockwise to decrease them. For the air-fuel mixture, start with the screw turned in gently and then adjust it out a quarter turn at a time until the engine runs smoothly at idle. Always ensure the engine is warm before making adjustments.


How do you adjust a carburetor on a 1987 Toyota?

The 1987 Toyota Camry does not have a carburetor. It is fuel injected.


How do you adjust the fuel mixture on a edelbrock carburetor so it don't run to rich?

You can purchase a kit from the manufacturer that gives you extra jets and metering rods.


How do you adjust a Harley Davidson carburetor?

To adjust a Harley Davidson carburetor, start by ensuring the engine is warmed up and at idle. Adjust the idle speed screw to achieve a smooth idle, then fine-tune the air-fuel mixture screw until you find the optimal balance, typically by turning it clockwise until it lightly seats and then backing it out 1.5 to 2 turns. Finally, test the throttle response and make any necessary adjustments until the engine runs smoothly without hesitation. Always consult the specific service manual for your model for precise settings.