Best Answer

There is a fairy long black plastic rod with screwdriver slot on top and to the right of the headlight.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:36:52
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you adjust headlights vertical aim on a 2001 626 LX?
Write your answer...

Related Questions

Why do you blow a fuse and lose your marker lights when you turn on your headlights in your 2001 Mazda 626?

There is a shorted wire or bulb in that circuit.

How do you adjust headlights up and down on a 1996 Mazda 626?

open hood. On top of each headlight there is an adjustment screw. Turn it either way to lower/raise the headlight

How do you adjust the headlights on a 1999 Mazda 626?

There is an adjustment screw in the top or side of the headlight nacelle. Turn it one way and it raises or lowers the beam and the other one moves it sideways.

When changing oil in a 2001 Mazda 626 how many quarts of oil is needed?

A 2001 Mazda 626 V6 - 4.2 quarts A 2001 Mazda 626 4 cylinder - 3.7 quarts

How do you adjust the parking brake on a 1995 Mazda 626?

The majority of time if you adjust the rear brakes it will adjust the park brake.

How do you change a brake light switch in a Mazda 626?

How do I adjust a stoplight switch on my mazda 626 LX V6

Will headlights and tail lights from a 1995 Mazda 626 fit a 2000 Mazda 626?

no you need the ones for the make of the car or else they will not work... trust me from experience

What are the release dates for Passions - 1999 1-626?

Passions - 1999 1-626 was released on: USA: 18 December 2001

How do you aim headlights on a 1993 Mazda 626?

Park your vehicle approximately 15 feet from your garage door or another wall. Open the hood and on top of both of the headlights you will see adjustment screws. Rotating them will lower/raise the headlights

What is the function of a Room fuse in a 2001 Mazda 626?

The room fuse in my '99 626 protects _ignition-off_ function of the power door locks, headlights, and some other functions, IIRC including all operation of the radio. For example, if the Room fuse is blown, my power locks work, but only with the ignition switch on. Doc

Cams adjustment of a Mazda 626 1997?

You can adjust the camshaft on your 1997 Mazda 626 with the camshaft adjustment bolts. You can access the camshaft adjustment bolts by removing the cylinder heads.

How to adjust vertical aim on a 96 Mazda 626?

There should be a screw just over the top of the headlight (you're going to have to get down on your hands and knees to see it). Screw it IN (clockwise) to adjust the aim higher. Park about ten ft. away from a building, on level ground. Measure from the ground to the center of the headlight. Now make a mark on the building at that height in front of the headlight. Adjust the headlight so it centers on that mark.

How do you adjust drive shaft length Mazda 626?

you dont! if you need that then you are buying a new cv shaft.

How large is the gas tank on a 2001 Mazda 626?

16.9 gallons

Is a 2001 Mazda 626 a interference or non interference engine?

i have a 2001 mazda 626 v-6 2.5 engine my timing belt broke i had the belt and tesioner pulley replaced and its running fine

Will a transmission for a 1998 4 cylinder Mazda fit in a 2001 Mazda 626?


Where is the gas filter on a 2001 Mazda 626?

Follow the fuel line from the engine to the tank.

Where is the EGR valve located on a 2001 Mazda 626 V6?

Under the intake manifold.

Is there a transmission sensor in a 2001 Mazda 626?

Yes, it has a speed sensor, about $125 online.

Why is the 2001 Mazda 626 check engine light on?

take it to autozone; orileys and find out for free

Why would 2001 Mazda 626 door ajar indicator stay on?

because your car is broke

How do you play asylum 626?

I can only be played during 6Pm to 6AM. adjust your computer time between 6pm to 6am in order to play it.

What is 23 percent of 626?

23 percent of 626 = 143.9823% of 626= 23% * 626= 0.23 * 626= 143.98

Where is the rear brake adjuster on a 2000 Mazda 626?

The 2000 Mazda 626 rear brake adjuster is located on the and of the brake pad. The brake adjuster is a screw. Your brakes should automatically adjust every time you back up and apply the brake.

Is there a 626 Mazda 2001?

yes, i am working on one at this time. A X MASTER AUTOMOTIVE, RICHMOND, TX