0
To adjust the idle control valve (ICV) on a Mitsubishi 3000GT, first ensure the engine is at operating temperature. Disconnect the electrical connector from the ICV and clean the valve if necessary. Then, turn the idle adjustment screw located on the throttle body carefully until you achieve the desired idle RPM, typically around 750-850 RPM. Reconnect the ICV, start the engine, and check the idle to ensure it remains stable.
What else can I help you with?
What are the model years of the Mitsubishi 3000GT show some pictures please?
I need to set the valve timing on a 1997 Mitsubishi 3000GT SOHC non-turbo charged. Can you send picture please
How do you install a blowoff valve on a Mitsubishi 3000GT VR4?
To install a blow-off valve on a Mitsubishi 3000GT VR4, first, ensure you have a suitable BOV kit and the necessary tools. Begin by locating the factory recirculation valve and removing it, then attach the new BOV in its place using the provided hardware. Ensure that the vacuum line from the BOV is properly connected to a vacuum source on the intake manifold. Finally, check for any leaks and adjust the valve's spring tension as needed for optimal performance.
Your 1994 3000gt stalls when you are stoped if you give it gas it is ok?
idle control valve
How do you adjust valves 2000 jeep wangler 4 cylinder?
They are not adjustable, the lifters self adjust to control valve lash.They are not adjustable, the lifters self adjust to control valve lash.
Where is the coil pack located on a Mitsubishi 3000GT and how do you replace it?
it is located on the left side of the front valve cover, where all the spark pug wires connect to....
How do you adjust the idle control valve on a 1988 Caprice?
You do not adjust the Idle Air Control as it is controlled by the computor.
How do you adjust idle speed for Toyota supra?
you can adjust it via the idle control valve.
Where is the idle control valve 2001 Mitsubishi galant?
Attached to the intake manifold
How do i replace a 3000gt egr valve?
To replace the EGR valve on a Mitsubishi 3000GT, first, disconnect the negative battery terminal to ensure safety. Remove any components obstructing access to the EGR valve, such as the air intake duct. Unbolt the old EGR valve from its mounting, disconnect the vacuum lines and electrical connectors, then install the new valve by reversing the removal steps. Finally, reconnect the battery and start the engine to check for leaks and proper operation.
What are the valve adjustments for the Mitsubishi pajero jr?
Please tell me how to adjust vavles for Misubishi Pajero JR ...H57A
How do you get the heater control valve to open on a 2002 Mitsubishi Galant?
Replace the heater control valve motor, a dealer part, costs around $166.00.ish
How do you adjust the mixing valve to control the temperature of the water flow?
To adjust the mixing valve and control the water temperature, turn the valve clockwise to increase the temperature and counterclockwise to decrease it. Experiment with small adjustments until you reach the desired temperature.
