Mazda
Mazda RX-7
DIY Projects

How do you adjust the idle on a 13B 1990 Mazda RX-7?

787980

Top Answer
User Avatar
Wiki User
2007-07-19 18:24:34
2007-07-19 18:24:34

on top of the upper intake there is a screw. it can be used to adjust idle speed.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

engine core - about 90kg's.

User Avatar

the American 13B-S5 has 200hp the JDM 13B-S5 (which is what I have) has 220

User Avatar

My 91 rx7 idles at 1000-1200, which i believe is the norm.

User Avatar

Depends, which engine is in the 85, 13b or 12a?

User Avatar

the idle up and down is due to the idle air control . coolant runs through it telling the engine what the air temp is and adjust intake air according to coolant temp .. or you might just need to make sure there is enough coolant in the system . as for smoke there could be a stuck open oil metering valve or injector or a bad oil seal . master Mazda tech .

User Avatar

on the 13b engine it should be behind the waterpump, just below the thermostat.

User Avatar

A 86 rx7 has a 13b wankel rotory engine only the turbo edition was turbo charged

User Avatar

It was a 94 with a Fortune body-kit. The engine was a 13b Rotary twin turbo with a street-port.

User Avatar

13b six port,whit asemmi pheripheral port cheep and powerfull sin.limites04@hotmail.com

User Avatar

for the past 2 years mine has bounced between 19-21 psi but then again that's in psi i don't know what your measuring in ?

User Avatar

I have an 87 7mge non turbo and i beat my buddies 89 rx7 with a 13b and webber side drafts

User Avatar

mazda rx7 Cars that have used a rotary engines 10A, 12A, 13B, 20B: mazda...Cosmos, R100, RX2, RX3, RX4, RX5, RX7,& R8 Rotary engines where first designed by Mercedes and then sold to mazda and build in Heroshima, they where also used by NASA in a single rotor format.

User Avatar

you can turbocharge basically any internal combustion engine, including rotaries, as Mazda did for quite a few years with their wenkel 13B 1.3 liter motors.

User Avatar

The Hindi movie 13B is not real. They just made that movie to make us scared.

User Avatar

12b - 9 + 2b - b = -87 13b - 9 = -87 13b = -87 +9 13b = -78 b = -6

User Avatar

some rx7 series 3s came out with a 13b motor ,an are only marginally bigger an i owned a series 4 13bt motor in a series 2 rx7 its one of the best engine conversions that you can do add toyota hilux diff with 4.3 centre out of a diesel hilux is much better pick

User Avatar

The body kit is $11,000. the engine is most likely a 13b-rew engine with a lot of extras. the car is a Mazda RX7 from the years 1993-1995. Go from there

User Avatar

Usually as a rule only mineral oils . Not synthetics ALTHOUGH there are some which Mazda ok ! Royal purple is one BUT at over $40aud per litre I'll stick with the mineral oil. Till I win lotto lol

User Avatar

9b-13b= -4b -4b = 40 Divide both sides by -4 b = -10

User Avatar

any engine will fit just about in any car. you will need new motor mounts, tranny, rear end, driveshaft, wire harness, and speedometer cable.

User Avatar

Yes, the engine block of the 13B rotary engine wieghs about 85-100lbs. its very small, most likely smaller than the 4cyl in the Protege. i know because i own 3 rx7's. hope this helps.

User Avatar

2007 nhyla 13b champions


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.