I found: http://bicycletutor.com/adjust-rear-derailleur/
It is specific for Derailleur (I was looking for Free Spirit's TORK DRIVE SYSTEM - 18 SPEED)
Torque mode in variable speed drives is where the drive adjusts its torque according to the input. The speed/velocity mode is where the input is used to control the motor's RPM.
to control a speed and torque.
Frequency drives are an adjustable-speed drive used for electro-mechanical drive systems. They control the motor speed and torque by varying motor input frequency and voltage.
You can either purchase a motor controller combo or visit your local club car dealer. Some, not all club car dealers can re-program your controller for more speed. Typically you will loose low end torque when they re-program for more speed. If you can't live with that a new motor and high output controller will allow you to keep your low end torque.
You should adjust your speed to a reasonable and safe speed. There is no specific number attributed to it.
A variable sped drive is sometimes also known as a variable frequency drive. These drives are used in electro-mechanical drive systems to control AC motor speed and torque.
Torque output of the engine at that speed.
bad torque converter in trans
Adjust your speed to condition, use only your low beams (and fog lights, if so equipped).
That you adjust your speed so you can react and stop within the distance lighted by your headlights.
An engine is a device that converts chemical energy in the fuel to mechanical and heat energy. This mechanical energy is used to drive a crank shaft which is used to power the wheels of an automobile. The crack shaft is connected to a gear-box which changes the speed and torque of the drive shaft. A lower gear (low speed and high torque) is used for acceleration from halt and a higher gear (high speed and low torque) is used for cruising.
Torque and speed are inversely proportional