0
How do you anchor guy wires when you can't drive a stake in the ground?
Wiki User
∙ 13y ago
To another fixed object.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the body to frame ground?
Generally near the battery. The factory topically anchor the wires within reach of the body ground wire because it all goes in at once.
Wiring diagram for pride classic disability scooter?
where are the ground wires located where are the ground wires located where are the ground wires located
1992 Gmc K1500 4.3L when you drive it drives good but with the trailer it stalls and shuts off when you stop?
check your ground wires on the trailer a faulty ground might be a problem
Hot wires in home wiring are normally colored and ground wires in computers are normally colred?
hot wires are black, white wires are ground
Where are the ground wires on a 2000 s10?
There are many ground wires in that vehicle, you need to be more specific.
What if the light fixture has two copper house wires?
If you mean 2 bare copper wires those are the ground wires. Tie them together and then connect the light fixture ground wire which will be green or bare copper to those ground wires.
Where do the ground wires on a 98 s10 blazer hook up?
Which ground wires? Most of them ground either to the chassis or the body. Any fastener which you can get a good ground with will suffice.
What's the different between white and green wires?
white wires are neutral. green wires are ground wires.
Hot wires in home wiring are normally colored and ground wires in computers are normally colored?
Hot wires in home are normally colored black. And ground wires in computers are normally colored black as well.
What does neutral do?
Neutral wires are actually ground wires. They enable the circuit to be completed.
Can you pigtail grounds in a panel in order to prevent double lugging on the neutral bus.?
The ground wires should not be terminated on the neutral bus. They should be terminated on to the ground bus which should be located on the back wall of the distribution panel. The wires don't have to be pigtailed when inserted into the ground bus. More that one wire can go under the terminal screws if you are running out of room. Shut the panel off and remove any ground wires that are now under the neutral bus terminals and move them to the ground bus. Some panels use a lug for a ground bus. All ground wires into the lug and tighten. In a ground fault condition it is the ground wires that are connected to the ground potential that trip the breaker, not ground wires connected to neutrals. Be safe.
Where are ground wires on 1994 buick lesabre?
There are many ground wires on this vehicle. The main one being the negative, (Black) battery cable.
