They all come with very detailed instructions, follow them carefully. Most important is gluing the fins absolutely parallel to the body. Also use a light glue like crazy glue, rather than white glue.
A basic model rocket consists of fins, the engine, the cone, the body, the shock cord, and the recovery device. In most model rocket sets the fins are glued to outside of the engine housing. In others, they are glued to the tube. If you have four fins on your rocket, place them bilaterally (across from each other and perpendicular). If you have three fins, divide the circumference as you would a pie, into thirds, and place each fin at a "cut" (don't actually cut the rocket!). The engine is secured by either a metal clip in simpler models, or by it's own housing and a plastic ring in more advanced models. Do not load the engine indoors.
Take the shock cord and tie one end to the nose cone. Fold the other end into a piece of paper, and glue it to the inside of the rocket, about three inches from the opening. Tie the recovery device (either a parachute or ribbon) to the nose cone where you tied the shock cord.
There are several site with instructions, here are a few;
Please see related links below.
Follow the instructions that came with it.
On an Estes launch rod, with an Estes electric trigger.
Buy and assemble an Estes model rocket kit. Use only commercial premade engines, never even consider making a engine yourself!
all i know of is estes
no
estes rocket is an online store that manufactures products for the model rocket world with designs made by modelers and established by Vern Estes over fifty years ago.They also make model airplanes made of balsa wood, foam,r/c planes and helicopters.
A person can buy an ignition switch for a model rocket from a few different places. Some of these include Estes Rockets, Model Aerospace Company, and Tower Hobbies.
Model rockets launch by sliding up a rod/wire that is pointing toward the sky. A launch lug is a small tube (like a drinking straw on a small rocket) glued to the side of the rocket body. You slide the small tube (launch lug) down on the rod. The launch lug and rod guide the rocket to start it in the correct direction until it gets going fast enough that the fins can stabilize it. Visit the links below. The first picture shows a rocket on the rod. It's a little hard to see but the rod goes through the launch lug. At the very beginning of the second link, they are sliding a large rocket lugs onto the rod.
Out Side On A Huge Field.
Apogee Rockets, Estes Rockets, Discount Rocketry, Rocket Fun, and Red Arrow Hobbies are just a few of the stores that sell model rockets and model rocket supplies.
It Can Cause The Rocket To Spin Out, and/or wobble of course
Yes, you can use other launch rods. They are all basically the same.
The reason is very clear in the laws codes and regulations that keep safty for other things in the sky and in your launch zone both in the sky and on the ground. If you cant see where it is going then you cannot say that it is safe and will not cause damage to those around you. Flying Conditions. I will launch my model rocket only when the wind is less than 20 miles per hour. I will not launch my model rocket so it flies into clouds, near aircraft in flight, or in a manner that is hazardous to people or property. I will launch my high power rocket only when the wind is no more than 20 miles per hour and under conditions where the rocket will not fly into clouds or when a flight might be hazardous to people, property, or flying aircraft. Prior to launch, I will verify that no aircraft appear to have flight paths over the launch site.