answersLogoWhite

0


Best Answer

Apply the prime pump mounted on the fuel pump for a minute or so. Then slacken the nuts that connect the fuel lines to the injector. Let an assistant start the engine until you see diesel oil pouring out, until there are no air bubbles left. Tigthen all the nuts again and the engine should run. When the engine is running, loosen and tighten each fuel line one by one, so there is absolutely no air left.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you bleed a 205 diesel after changing the fuel filter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

After changing the fuel filter on your truck you cant get it to start?

bleed the fuel and then start or manualy fill the new fuel filter and then try it


Where is the fuel filter located on your 2004 Pontiac Bonneville?

fuel filter is located in front on right rear wheel mounted to the frame. bleed fuel pressure before changing it


Where is fuel filter located on 2004 Pontiac Bonneville?

fuel filter is located in front on right rear wheel mounted to the frame. bleed fuel pressure before changing it


How do you prime a 1999 ford 7.3l powerstroke diesel?

wont start after changing fuel filter


Why wont a 2002 Cummings turbo diesel engine start after you change the fuel filter?

Did you prime the fuel system after changing it?


Bleed fuel line ford 250 pickup diesel 2005?

bleed fuel line ford diesel 250 pickup 2005 how does one bleed the fuel lines in that truck ?


How do you crank a ford 4610 tractor after changing the fuel filter?

What I have done to bleed the lines in my 4810 Diesel after changing the fuel filter is this.. 1. Obviously, bleed the filter housing to get the filter primed and the air out. 2. If the tractor won't start...i will swing the battery out exposing the injector lines into the block...while cranking the engine over, loosen each injector line one at a time until fuel seeps from the fitting, then re-tighten while it is pumping. Usually by the time you bleed the 3rd injector, the engine will fire up... *Obviously...safety is paramount...make sure tractor is in neutral and parking brake is engaged.


How do you bleed a ford courier diesel van?

The earlier Courier's had a primer pump on the fuel filter. The later ones are self bleeding.


Why won't 1992 dodge diesel start?

No fuel, dead battery, plugged fuel or air filter, no oil & seized the engine, or many other things. If it cranks over I would guess it is the fuel system. Drain the gas and put diesel in, replace the fuel filter, bleed the lines and it should work.


How do you change fuel filter on Peugeot 806 diesel?

How do you change fuel filter on peugeot 806 diesel?


Where is the fuel filter on a c3 citroen?

The diesel engine Citroen C3 have the fuel filter located in the engine bay, under the air intake pipe to the air filter. There are some pictures on this forum post: http://citroenc3owners.com/diesel-c3-tips/how-to-change-the-air-filter-on-a-citroen-c3-1-4-16v-hdi-t80.html and some instructions to remove the diesel filter here: http://citroenc3owners.com/diesel-citroen-c3/changing-the-diesel-fuel-filter-t102.html The petrol engine Citroen C3 has a filter in the fuel tank that lasts the life of the car.


How do you bleed fuel filter on Land Rover discovery 3?

how to bleed fuel filter on land rover discovery 3