You do something.
The slave cylinder is on the input shaft of the transmission at the throw out bearing. The transmission will have to be removed to change it.
unbolt from trans.bolt on new one bleed system
your slave cylinder is bad or empty,so the clutch isn't disengaging.replace it,fill it with brake fluid,bleed the line,and it should work fine
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
Replace the slave cylinder.
bleed it the same way u bleed the brakes
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
There is no bleed screw on the 3.4 clutch. You have to unbolt the slave cylinder from the trans and drop it down so that it and the line are lower than the master cylinder, then pump the piston in/out to force any trapped air up to the master cylinder.
The same way you bleed brakes, but use the little bleeder valve on the slave cylinder. The same way you bleed brakes, but use the little bleeder valve on the slave cylinder.
Fill your slave cylinder using a hypodermic syringe (won't take much) and install it. Before you tighten the connection to the slave cylinder, bleed the air out of the line by filling the reservoir and pumping the air out until it runs clear. After it runs clear, tighten the connection to the slave cylinder.
Sure, but you also need to get the air out of the lines and the master cylinder. Put the slave on, then bleed the clutch keeping a supply of brake fluid in the reservoir.
remove 2 bolts holding it on,then replace, follow line back to bleeder valve,bleed,then bleed at slave cylinder