0
What else can I help you with?
The clutch pedal on your 89 240sx sticks to the floor it has a new clutch what do you do?
Bleed the slave cyl. It probebly has air in the line or no fluid.
How do you repair the clutch slave cylinder on a 1993 Nissan 240sx?
To repair the clutch slave cylinder on a 1993 Nissan 240SX, first, safely lift the vehicle and remove the rear wheels for better access. Disconnect the hydraulic line from the slave cylinder and remove the mounting bolts to take the cylinder out. Replace any worn seals or the entire slave cylinder if needed, then reassemble everything and bleed the clutch system to remove air from the lines. Finally, check for leaks and ensure proper functionality before lowering the vehicle.
Why will the clutch not pump but will stay all the way up or down in a 1990 Nissan 240SX with manual transmission added clutch fluid?
I would suspect that the clutch slave cylinder is bad. Follow the line down from where you added fluid to find the slave cylinder. After replacing the slave unit you will need to bleed the system then it will work fine again. Mark
How do you bleed the Mercedes c180 clutch?
You can bleed the clutch by loosening the fluid line. With the line loose pump the brakes until fluid comes out.
How do you bleed the clutch line on a 2004 ford ranger edge?
how do I bleed the clutch system in a 2004 ford ranger
What can the problem be when a 91 Nissan sat for a long time and the clutch pedal is stuck to the floor?
check your clutch fluid lines and your clutch fluid and also bleed the clutch and it should work just fine mine did the same thing and i had to replace a clutch line that was pinched
If you just replaced the clutch master cylinder on a Nissan 240sx then why won't it build up pressure?
The most likely case would be that air somehow got into the line. try bleeding the clutch fluid, while making sure that the level in the reservoir does not get low.
How do you bleed the air in your clutch line on a 1997 gmc sonoma?
same as bleeding the air in the clutch line for any other car -stab the air.
What is the cause of a 97 elantra clutch pedal getting completely stuck?
You need to bleed your clutch master cylinder line.
How do you adjust a clutch on a 1987 Pontiac Fiero?
There is no clutch adjustment. The clutch is hydralic and therefore needs no adjustment. If the clutch isn't working correctly you most likely have to bleed the clutch line.
Why does your 1986 Nissan pick up it leaks the clutch oil by the transmission?
Is the leak coming from your slave cylinder,it has two bolts holding it on,with a rubber cover,if so ,you need to replace and bleed it and your clutch damper,its on the left side of fire wall,just follow your clutch line from clutch master cylinder,20.00 for slave cylinder.,
How do the timing marks line up on a 1992 Nissan 240SX 2.4 engine?
Get a manual on your car, It will have pictures and everything,.
