You need to bleed the clutch
on your clutch pedal
on the clutch pedal lever
Well, we need lots more information here. Is the clutch pedal actually "stuck" to the floor? In other words, can you NOT lift the pedal up to the normal position? OR, has the clutch pedal "fallen" to the floor due to no resistance from the clutch?
You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.
check your clutch slave cylinder for leaks,its bolted on your transmission,about 20 bucks
It's called: Your clutch is working.
You have a broken clutch.
The clutch cable has proabably broken.
It gives the clutch pedal a softer, smooth feeling. Some people remove these for a more direct pedal feel
where and how to adjust clutch pedal 1993 s10 It is hydraulic operated, there is no adjustment.
To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.
u must bleed the system . fill the clutch master cylinder with dot 3 brake fluid and keep an eye on it when bleeding so it wont run out ,have someone pump clutch pedal 3 times and hold to floor and oper bleeder valve on clutch slave cylinder till no air comes out then go to clutch damper and do the same ,follow clutch line fromclutch master cylinderto damper.
yes. u need a new transmission. you might also want something to close the hole in the floor from where the clutch pedal was
depress the clutch pedal to the floor several times
Actually if the fluid is coming down the clutch pedal it is probably your clutch master cylinder going bad or the seal around it. No worries it is a cheap fix. If it is coming down the clutch pedal it has nothing to do with your brakes. Some people well most use brake fluid for the clutch.
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
The clutch Throw Out Bearing is going bad.
If the pedal just randomly falls to the floor, you probably have a broken pedal or linkage. If we are talking about it having no resistance when you press it and the clutch not disengaging, you probably have a leak in your clutch hydraulics. This can be a bad master or slave cylinder, or a leaky line. Bleed the clutch, and then keep checking the fluid daily to see if you are losing it.
Sounds like you may have air/leak in the hydrolic line. Try bleeding the slave cylinder.
You may need a new clutch.
You can find the flasher relay on Nissan Hardbody on the metal flange of the clutch pedal.
sounds like your slave cylinder is bad or your clutch, find your clutch fluid reservoir and see if its full ,if not look for a leak if there is a leak most likely that's the problem and needs replacing.
Attached to body behing brake pedal (if automatic) clutch pedal (if standard)
you can't its hydraulic, if the pedal feels weird just try bleeding the clutch system