0
if u want to talk u can talk about the wwe ok
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where do you add clutch fluid to a 85 Honda prelude and will i have to bleed lines?
85 Lude, old school cable clutch... No hydraulics (fluid)
Why is the brake pedal feel so low and spongy after a brake change on a 1995 Honda Civic?
You probably have air in the brake hydraulic line. Bleed the air out of the brake lines.
How do you bleed the brake lines after replacing brake pads on a dodge Dakota?
If you did not open any brake lines and only replaced the pads there is no need to bleed the system.
How do you get the air out of the brake lines in a 91 escort?
Bleed the brake system.
How does a brake bleed screw work on a 1998 Nissan Pathfinder?
The bleed screw on the calipers of brake systems are for 'bleeding' air out of the brake lines.
Why does brake pedal feels spongy?
air in the brake lines theyneed bleed
Air in brake lines?
Then you need to bleed the brake system to remove the air.
How do you depressurize the fuel lines on a 1987 Honda Prelude?
open the gas cap
How do you bleed the air from brake lines of 2007 Chevy Cobalt ss?
The same way as you bleed any other brake system.
How do you fix squishy brakes on a 1997 couger?
You Probably have air in your brake lines Or you may have low brake fluid. Mechanics can bleed the brake lines which will remove the air out of the lines. I do not recommend doing this yourself.
If you make a mistake and put motor oil into your brake fluid could you lose your brakes and how long would it take to go through the system before you have no brakes.?
Good time to replace all the brake fluid. Remove the brake lines from the Master Cylinder and pump the master cylinder dry. Add fresh brake fluid from an unopened can and bleed the master cylinder. Reinstall the brake lines and then bleed all brake lines until you see clean fluid. Keep adding fluid to the Master Cylinder until you are done.Good time to replace all the brake fluid. Remove the brake lines from the Master Cylinder and pump the master cylinder dry. Add fresh brake fluid from an unopened can and bleed the master cylinder. Reinstall the brake lines and then bleed all brake lines until you see clean fluid. Keep adding fluid to the Master Cylinder until you are done.
Will a Honda vtec motor fit in my 96 Honda prelude?
It depends on what kind of VTEC motor is being swapped into a 1996 Honda Prelude. The H22 series certainly can be swapped in, as it was in the higher trim lines of both 4th and 5th generation Preludes.
