answersLogoWhite

0

how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Is there a coolant bleed valve on a Chevy s10 4.3L v6?

No.


How do you bleed air out of coolant system 97 Saturn?

procedure on how to bleed air out of coolant system on 97 saturn ls


Where is cooling system bleed valve located on 1999 alero v6?

The coolant air bleed valve is located on the top of the thermostat bypass pipe/heater pipe assembly. Close the valve once a continuous stream of coolant is expelled from the valve.


Where is the place you bleed coolant system?

It is not necessary to bleed the coolant system. If you mean "drain" the system, there is usually a plastic plug on the radiator or, you can pull the lower radiator hose off.


How Do you Bleed The Coolant System On A 1998 Beetle?

To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.


How do you bleed the coolant system on a 2002 impala?

There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.


How do you Bleed the coolant system on a 2002 Chevrolet Impala?

There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.


How do you bleed coolant system after replacing thermostat?

what is the year make & modle of it??


How do you bleed the coolant system on a 1999 mercury villager?

Not necessary on this vehicle.


How Do you Bleed The Coolant System On A 1998 2.0 Beetle?

Start by taking the top off of the coolant overflow reservoir. To bleed the system, run the 1998 VW 2.0 Beetle about 10 minutes, then check the coolant level. Add coolant if needed, then replace the reservoir top.


How do you bleed my coolant system?

As you did not include engine or Year info I will give a general answer. Look on the top of the engine, most GM products with a bleed system have a small brass pipe thread plug in the top of a black or aluminum casting. This is the bleed point, loosen the plug or valve and add coolant to the system until it flows from the bleed, tighten up the bleed. Done. Repeat if needed.


Where is the coolant temperature sensor located on a 2004 sebring?

For the 2.7l v6 engine, it is right on top of the engine next to the coolant bleed valve. As you are standing in front of the car after raising the hood, look right to the left of the intake manifold. There you will see the coolant temperature sensor and connector and the coolant bleed valve, both in the same plastic housing.