First, clear the shotgun and make sure it is completely unloaded. Open the action halfway and unscrew the takedown screw. Pull the barrel forward and remove. Push the trigger housing pin out of the shotgun and pull down the rear trigger guard. Remove the cartridge stop and cartridge interrupter. Pull the bolt slide out of the bottom of the receiver. Push the forearm grip forward and off the gun. Push the bolt out of the hole where the barrel was. Move the elevator out of the bottom of the receiver and you are finished.
Burn it!
Seperate it into smaller pieces
Should be the same as Winchester 1400 shotgun. Email me for a copy of the manual.
If you do not have a manual, you need to visit a gunsmith.
Seek the services of a good gunsmith
NO. This could break down your grooves.
Shoot it about 2000 times without cleaning it. It will break down!!
Try to pull it back. DO NOT LET IT SLIP OUT OF YOUR CONTROL!!!!!!!!!!!! If it doesn't move, take it to a gunsmith.
they break down the oil into microscopic pieces and eat them
Send me your email & I'll send you a copy of the original manual.
Impossible to answer since you don't provide the type of action (OU, SxS, Pump, Semi-Auto)
Best bet is to find a gunsmith