0
How do you calculate amount of copper used in a motor AC or DC and generator and transformer Datasheets do provide power rating and mass of the equipment can we somehow use this available info?
Wiki User
∙ 11y ago
One thing you could do is look up the datasheet for the motor and/or contact the manufacturer of the motor. Also, if you know the guage of wire, you can calculate it based on the resistance of the coils on the motor/generator or on the coils of the transformer
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Can you use any ho transformer for a ho train set?
As long as the transformer is capable of 12 Volts DC output, you can use any transformer with HO scale equipment.
What equipment uses Nlb200050w1a ac adapter?
Transformer Power Supply
Will 120 volt equipment work on a 110 volt transformer?
Yes.
Can you use transformer with your 110 aircon?
A transformer can be used to change the voltage to an appliance. The voltage rating of the transformer should be right for the voltages used, and the current rating of the transformer should not be less than the current drawn by the equipment.
What piece of equipment is used to protect the technician from a potential fatal shock when working on hot chassis products Circulation transformer Isolation transformer Steppe transformer?
circulation transfomer circulation transfomer
Is transformer is a device?
b'coz transformer is not a moving parts so it works on the princeple of mutual induction
Can you power American equipment from a 220 -125v step-down transformer or must it be 110v?
No
What does a buck boost transformer do?
A buck boost transformer is a type of transformer that is used to make adjustments to the voltage applied to alternating current equipment. These transformers are typically used in back up supplies or in tanning beds.
Why does someone have to be careful around a high voltage transformer?
A high voltage transformer is a very dangerous piece of equipment. The voltage level is enough to electrocute a person if handled improperly. Only trained professionals should work with this type of equipment.
Why would you use a three phase transformer in place of a single phase transformer?
the necesscity of two three phase transformers operating in parallel are as follows...if the one transformer fails to give supply,then another transformer can be used in parallel and hance,continuity of supply can be maintained.one transformer can be easily take out from the supply for repair & maintanance.if the load on the substation increases beyond the rated values of transformer, then another transformer can be used to share rhe load of the substation.
Is it possible to use a 110 volt product with 240 volt?
Yes provided that you use a transformer that will transform 110 to 220/240. Without the transformer you will blow your equipment. You can take a USA appliance and go to Europe and other places that use 220/240 and use it but only if you have a transformer that is in range with the power consumption of the 110 equipment. Most small/portable electrical equipment like computers, tablets or phones bought in the USA are now coming with dual voltage 110/240, so there is no need for transformers. If you equipment does not says 120/240 or 110/220 you WILL need the transformer.
Difference between isolation transformer and Scott-T transformer?
The Scott-T transformer was used to run 2-phase equipment from a 3-phase source. Older power distribution systems (and equipment) were 2-phase. An isolation transformer usually has the same input and output voltages (120:120, 240:240, etc) and is used to isolate the source from the load. Isolation transformers are used in medical equipment, for instance, to prevent a patient hooked up to a monitor from being electrocuted during an electrical fault.
