0
heres what i did for both front cv shaft:
jack car up onto jack stands.
remove wheels
remove brake calipers
remove brake caliper mounting bracket
remove rotor (use impact hammer to remove rotor screws or drill the heads off)
unbolt lower ball joint
use pickle fork to pry ball joint from hub
(this will likely ruin the rubber on the ball joint, so replace. otherwise use a tie-rod end puller the remove)
pry the dent out of the keyway on the end of the drive shaft
use impact wrench to remove driveshaft nut
use 6" jaw gear puller to remove hub from end of drive shaft
yank on driveshaft hard to remove from tranny
What else can I help you with?
Timing marks for 1997 Kia Sportage?
I need to know the timing marks for when I put both the cam shafts back on and the head torque specifications for a 1997 KIA Sportage, two wheel drive.
Where is the thermostat on a 1997 KIA Sportage?
how do u change thermostat in a 1997 kia sportage
How do you change the oil on a 1997 Kia Sportage?
carefully
Where is the horn located on a 1997 Kia Sephia?
where is the horn for a 1997 kia?
How do you shift in and out of 4 wheel drive in 1997 Kia Sportage?
only from a stopped position. Do not try and do it on the fly. Not designed to do that.
How many spark plugs are in a 1997 Kia?
how many spark plugs are in a 1997 kia?
How many CV Shafts does my 4-cylinder 2004 Kia Optima have?
you have two left/rights
How do you change a clutch in a 1997 KIA Sportage 4 wheel drive?
have to completely pull tranny and 4 wheel diff.then replace clutch and re-install back in. Not for a novice,may want to leave this one to the tranny man.
Where are the grease fittings on 2000 Kia Sportage?
all the ball joints are self lubricated, meaning no grease fittings, you cannot grease them or the steering joints, you can grease the front and back u joints on the drive shafts,but that is all.
How do you change a clutch on a Kia Rio 2004?
To change the clutch on a 2004 Kia Rio, first, disconnect the battery and lift the vehicle securely. Remove the transmission by detaching the drive shafts, shift linkage, and any necessary bell housing bolts. Once the transmission is out, replace the old clutch disc, pressure plate, and release bearing with new ones, ensuring they are correctly aligned. Finally, reassemble the transmission, reconnect all components, and test the clutch operation before lowering the vehicle.
How do you change the head light and parking lights on a 1997 Kia Sephia?
take out the old bulb and put the new one in :)
Where is the carrier bearing on the driveshaft on a 2001 Kia Sportage?
its located between the two shafts above the center support
