0
It's part of the driveshaft outer cv joint. Replace the shaft as per 2002 Clio 1.5dci
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is front abs sensor peugeot 406 2000?
ring on drive shaft with senser next to it. usual fault! cracked by rust ring on drive shaft. change shaft.
How do you repair a split abs sensor ring on the off side drive shaft of a UK 2001 Chrysler Neon LXi Automatic 2000cc?
Replace the half shaft.
Abs light is on after they change your clucth y?
they forgot to put the ABS ring back on after removing the axle.
Where is the abs sensor for 1992 chev truck?
If it is a 2-wheel drive then it is on the transmission tail shaft housing. If it is a 4-wheel drive then it is on the transfur case.
Do CV Joints have any connection to abs your car is making a clunking sound when steering wheel is on full lock shortly after this 1 week your abs warning light is on?
On some vehicles, the abs tone ring (what the sensor reads) is on the cv shaft.
How many ABS wheel sensors on Chevy 98 1500?
It has 1 on each front wheel and 1 on the transmission tail shaft. If it's a 4-wheel drive then it will be on the transfur case tail shaft.
Where is the rear abs sensor on a 99 GMC sierra 1500?
If it's not a 4x4 / 4-wheel drive then it is on the rear tail shaft housing on the transmission. If it's a 4x4 then it will be on the tail shaft housing of the transfur case.
Where is the abs sensor location?
It can be located on each wheel end to read the inside the rotor, or it could be in the rear end close to the drive shaft. It depends on the type of antilock brake system you have.
Where is abs sensors on Ford Explorer Sportrac?
inside front rotors,you well see wiring going to sensors,the rear sensor only one at the diff.right above drive shaft.
Where is the rear abs sensor located?
It can be located on each wheel end to read the inside the rotor, or it could be in the rear end close to the drive shaft. It depends on the type of antilock brake system you have.
How do you change rear wheel bearings on1994 Toyota 4runner?
i hope you are not thinking of doing this job at home . 1 remove wheel 2 remove the brake shoes 3remove the handbrake cable mountings of the backing plate 4 remove the wheel cylinder 5 undo 4 axle shaft hold down bolts just behind the backing plate 6 pull out the axle shaft assembley 7 mount the axleshaft on a vise(be careful it is heavy) 8 use the gas torch and heat the abs reluctor holding ring until it starts to fall off the shaft 9 heat the abs reluctor it too should fall of once it is heated to the correct temperature 10 remove the c clip 12 heat the wheel bearing retaining ring till it falls off the shaft 13 put the axle shaft on to a hydraulic press and press out the aring of the shaft and the backing plate 14 reverse order to install
Where is the abs sensor located on dodge ram 1500?
on a 2000 dodge ram 1500 the abs sensor is located on the rear end above where the drive shaft meets the rear end, if it is bad there will be a brake light on in your dash and may rev high in first gear before shifting into second If it has 4 wheel abs there will be a sensor at each front wheel bearing.
