If you look at the top of engine but in the back. You will see the Distributor cap
and wires. Mark the wires where you understand where they go. Then remove
the wires. There is 2 small screews on each side of the cap, remove them and
lift cap off. When you put new cap on, make sure it is sitting stright and flat on
the Distributor. If it's not right then the screews will not start. It's a little trickey.
Then put wires back on were they go.
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
There is no distributor cap, only a ciol pack that the plug wires go to
Yes, a 1997 Chevy Cavalier does have a distributor cap. The distributor does not have points and a condenser. This part is one electronic unit.
If your S10 has a 2.2L engine, it doesn't have a distributor cap.
It doesn't have a distributor cap.
I don't know what your specific problem is, but there is no distributor cap.
on this old distributor there is a cap that holds the wires in place on the distributor. Is there a trick to remove top cap?
The 93 Beretta does not have a distributor, it has coil packs.
it does not have a distributor , it has coil packs
There are two screws that hold it to the distributor.
No, it has coil packs, there is no distributor.
There is no distributor cap as there is no distributor. There are 3 coil packs, each coil fires 2 spark plugs simultaneously.