The headlight assembly has 3 screws that need removed. After removing the screws, then remove the headlight. The turn signal is located in the side light assembly. The blinker or turn signal assebly will pull forward and come out. After pulling it forward you can unsnap the wire and turn the blinker bulb, loosening it, then remove and replace. Be careful replacing the blinker assembly. There is a small part that "snaps" together when it is installed properly. If you do not install properly it will be O.K. but will not be lined up correctly.
You can change the front turn signal, on your 2006 Pontiac Montana, by removing the retaining nuts. Remove the wiring harness. The turn signal will come free. Reverse the process to install the new turn signal.
How do you change a front blinker bulb for a BMW X5 2001?
front or rear?
2002 Montana Seat Repair
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
on the front of the engine
Take the whole lens out
I have a 2004 Montana myself and just used google to find this video: http://www.youtube.com/watch?v=rBfroF_GRPg It's the best one out there! Good luck.
Check front end for play.
you must remove the front suspention crossmember and suspension.
you have to remove the front suspension, and the cradle or frame that is bolted and holds the engine in.that is the only way to get to the oil pan.
I don't know, I have the same question.