0
jack up car and remove wheel.... disconnect brake caliper. can clamp the line with vice grips or similar if not too fussed or not sure how to get brakes back on. remove centre nut on shaft which may need bit of encouragement with a long bar and prob 29mm socket. then pull disc off and u will be looking at the bearing..
i could be wrong its been bout 6 months since i done all 4 on my car.
hope this helps.. dont be scared its actually easy.. just remember what goes where and do everything back up tight.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Installing Ford Festiva front wheel bearing?
To install Ford Festiva front wheel bearing, the engine must be stopped and the car taken to a flat surface. The jack is usually used to lift the vehicle.
How do you change front wheel bearing in 2003 Kia Sorento?
how do i change front wheel bearing of kia sorento 2003
Change 1998 jimmy 4x4 front wheel bearing?
How do you change a 1998 jimmy 4X4 front wheel bearing ?
Install Ford Festiva wheel bearing?
Installing wheel bearing in a Ford Festiva is simple but will take some time. All you have to do is take the hub off, take out the tie rod and then take out the wheel bearing from the hub.
How to change front wheel bearing on fiesta?
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
How do you change the front wheel bearing on 2006 mercury mariner?
Change wheel bearing on 2006 mercury mariner
Change front wheel bearing on 1998 mercury mountaineer?
how do you change wheel bearing on 98 mercury mountaineer
Change front wheel bearings on Honda ATV?
how do you change front wheel bearing for 420 rancher
How do i change the bearing on a 1996geo tracker front of a 4 wheel drive?
how do I get to the front bearing on a geo 4 wheel drive
How do you change front left wheel bearings on 91 Ford Festiva?
send it to a mechanic
How do you change the wheel bearing on a 1998 Honda Accord ex?
how do you change a 1998 Honda accord front wheel bearing
How do you change a front wheel bearing on a Chevy Lumina?
Remove the tire and wheel from your Chevy Lumina. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.
