* Remove the upper air intake splash shield * Remove the headlight housing retaining bolts and pull the housing assembly out to access the bulb * Working at the rear of the headlight housing rotate the bulb holder counterclockwise to separate it from the housing while setting the housing aside * Unplug the electrical connector from the bulb holder
I would suspect the brake light switch is broken or out of adjustment. The switch is located just above the brake pedal pad. or i think that brake is stuck??
To change the license plate light on a Pontiac Sunfire, first remove the cover over the bulb with a small screwdriver. Gently push on the bulb and turn 1/4 turn to remove the old bulb. Insert the new bulb and snap in the cover.
In order to change the signal light, you need to look under the bumper. There are 5 to 6 bolts that need to be removed in order to remove the cover.Ê
Fold down the rear seat and it is right above the rear seat.
i had it looked at and they said it was the oxygen sensor could that be the problem if so how hard is it to change.
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
You have to remove the tail light lens cover from inside the trunk- there are about 6 nuts holding it on --the whole cover comes off and bingo there are your lites for the Pontiac emblem that lights up!! There are no lights persay just for the Licence plates on my 96 Sunfire and I assume the same on a 98
No
What causes a 1997 Pontiac sunfire gt with a 2.4 liter engine to stall when stopped at a light
Why the hi beam and day light are not working but the low beam are working good on sunfire 99?
Yes, the dash light dimmer switch is located next to the headlght switch. You rotate it one way and the lights dim out, rotate it the other way and they get brighter, keep rotating it that direction and the interior light comes on.
Defective sensor? Usually in coolant recovery trank