answersLogoWhite

0

You will need to drop the oil pan to change the oil pan on a Hummer 2. The oil pan is located in inside the oil pan. You also need to first drain the oil pan of the old oil before you drop the pan.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Change oil pump in a 2000 Chevrolet Silverado 4.3 2 wheel drive truck?

how to change oil pump in a 2000 Chevy silverado 4.3 2 wheel drive truck


Where is the oil filter located on a hummer H3?

Remove 2 skid plates under engine, oil filter is in front of engine above front skid plate with the Hummer logo on it.


How do you change an oil pump in a 98 Monte Carlo?

remove the oil pan,them pump is located in there,should be held on with 2 bolts,either 10 or 13 mm


You need to change the oil pump should you replace the engine?

yes this is very important to do after all of your oil pump changes which you should do about once every 2 months


Changing oil pump 1995 Geo Prism?

You'll need to drop the oil pan to replace the oil pump. There are only 2 or 3 bolts holding the oil pump once the pan is out of the way. The oil pan is the difficult part. The pump is easy. However... Oil pumps seldom fail. If you have low oil pressure it's usually because of excessive rod and/or main bearing wear. Change to a higher viscosity oil before you try to change the oil pump.


How do you change the oil pump on a 2000 Dodge Durango 2 wheel drive with a 318?

drop the oil pan and it's in the rear sump


How do you change the oil pump in a 1999 Cadillac escalade?

drain motor oil, remove oil pan , locate oil pump , it has 2 crews. replace oil pump with new one. replace oil pan gasket with new , put oil pan back make sure all screws are tight but not tooo tight . put back motor oil 4 1/2 to 5 quarts .. done check for leaks around oil pan.


Why does oil pressure gauge rise as you accelerate then drop after gear change just had oil filter and oil change its a ford probe 16 valve 2 l?

The oil pump turns more at higher revs, this is then producing more oil pressure, so when you change gear the revs are in a lower range so the oil pressure drops.


How do you change external oil pump on 98 Ford F-150 4.2 v6?

this i my experience for a 1997\98 ford f150 4.2 v6. It is very easy. step1 get ready to get greasy and deal with the task ahead of you lol.1 This year make and model has a external oil pump.1st step remove drain oil. 2. remove oil filter connected to the oil pump. 3. why you are at this point you might as well change the oil sending unit above the oil pump.this is the little device that is connected to a connecter with one wire.NOTE: be carefull to remove female connection very sensitive. 4. Oil pump has 6 bolts to unmount or loosen.5. when all are loosened be care to remove oil pump. 5. make sure to remove old gasket from block if still connected. Clean surface of block. And now you have removed the oil pump. *****GOOD LUCK ON INSTALLING****** Make sure you are to prime oil pump and use torq wrench specifications and tightining order.


Why does Oil light comes on at idle speed goes out with acceleration on 2001 Ford Taurus?

* low engine oil level * plugged oil filter * oil pump is failing * oil pressure sending unit is failing The first 2 are eliminated with a fresh oil change.


Where is the oil pump on a 1994 Dodge Dakota?

oil pump is going to be 1 of 2 places. inside your oil pan, or where your oil filter attaches. never worked on a Dakota but have never seen a pump anywhere else. hope this helps.


You own a 2006 Audi A4 2.0T Quattro low red oil pressure light comes back every couple of days car was at the Audi dealer 6 times and Audi replaced oil pump the sensor and change oil 2 times.?

the oil pump has a metal pipe going to it, theres a filter on it that's probably clogged. doubt they changed that line. tell them to remove it and change or clean it