* Drain the coolant and dispose of it properly. (there are companies that will recycle used ethylene glycol coolant) * Disconnect the two large radiator hoses. * Remove the fan shroud from the radiator. * Remove the two retaining brackets at the top of the radiator. OBSERVE THE RUBBER MOUNTING PADS! Don't throw them away! * The radiator should lift straight up once the retaining brackets are removed. Again, keep track of the two LOWER mounting pads. You'll need them later. * Verify that the mounting pads are in good condition and that you have all 4. Replace any that are missing or damaged. * Put the NEW radiator in place using the mounting pads and tighten down the retaining brackets. Reattach the fan shroud and radiator hoses. Fill the cooling system with appropriate coolant.
get a clue...
Assuming it is the same as my 1996, there is actually a plug at the bottom driver's side of the radiator. It is just a little tight for my arms, but if you shine a flashlight down you can see it.
The radiator drain on a 2004 Chevrolet Tahoe 5.3 is on the bottom of the radiator. It is on the right side and has a cover over it.
how much oil does a 1996 Tahoe hold
It is on the bottom right side of the radiator facing the engine.
To change the thermostat on a 97 Chevy Tahoe, drain the radiator. Locate the part under the upper hose register and loosen the screw holding it in place. Replace it by putting in the new part and bolting it back down.
How do you drain a 1996 Seville radiator
only way to change lower radiator hose is to get underneath the vehicle there is a fawcet on bottom of radiator to dump coolant, then remove hose from underneath vehicle
Yes it will go right in there, and don't have to change nothing.
where is the back wipers water pump locate on a 1996 chevy tahoe
How to remover 1996 ford mustang radiator fan from the radiator motor
yea but you have to change the mounts and the radiator but why would you do that just turbo it