You will have to pull the transmission and flywheel the rear main seal is on the back of the engine, and it will be a 1 piece seal that goes over the crank shaft and drives into a houseing that holds the seal in place. need to lube crank with grease or oil before installing seal. You will need a seal driver. You can not get to it by removeing the oil pan. You can pull the engine out and leave the transmission in and get to it that way. IT IS EASER TO REMOVE THE TRANS.
how do you change a rear main seal in a Chevy 350 motor
You MUST remove the oil pan to change the rear main seal. It's the only way because it is a 2 piece seal that fits in the rear main cap and block.
How do you change a rear main seal on a 2001 Chevy 2500 HD long bed
Chevy S10 pickup 4cly 2.5 engine,how to change rear oilseal
The engine rear main seal can only be replaced with the engine or transmission out of the vehicle.
Either drop the tranny or pull the engine.
you have to pull the transmission out-- or the enging which either is easier
You have to take the oil pan off, then the oil pump, then the rear main cap. They make a tool called a chinease finger to get the upper half out, and the new one in around the crankshaft.
Between 350 to 400.00 dollars depending on who does it.
Yep, they have one. 1986 and older has a two piece rear main seal. 1987 and up has a one piece rear main seal.
how is the easiest way to change a rear main seal in a 460 ford
Not enough clear information ! - Rear main seal on WHAT - ? ?