0
Call Hubby.....
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Need to find your relay switch in your 1995 Pontiac transport minivan with a 3800 v6 engine?
under the hood on the left side by the bat
Where is second fusebox on a 1995 Pontiac transport?
Under dash
Where is the heater blower motor in a 1995 Pontiac transport?
The heater blower motor in a 1995 Pontiac Transport is located on the passenger side of the engine compartment. It is on the firewall near the hood hinge.
Where is the 1995 Pontiac transport AC relay?
The 1995 Pontiac Transport air conditioning relay switch can be found in the fuse box. The air conditioning relay switch will be at the top of the third column.
Where is oil pressure sender for 1995 Pontiac transport?
Oil pressure sender /fuel pump switch for 1995 Pontiac transport 3.1 is located between oil filter and starter at front of engine.
Where can you find a wiring diagram for a 1995 Pontiac transport?
on this site you should find one --->
How do you change a starter on a 1995 Pontiac Bonneville SSE?
how do you change a starter in a 1995 Pontica Bonneville?
Where is the blower motor resistor on a 1995 Pontiac transport?
Its on the fire wall in motor compartment rt next to blower motor. Easy to change ! Five min. Job.
How do you replace the ignition switch on a 1995 Pontiac Transport?
By taking it to a GM certified auto technician.
What are the locations of the speakers in a 1995 Pontiac transport van?
speakers are on the front dash and back hatch door.
Why would the wipers only work intermittently on a 1995 Pontiac Transport SP Minivan?
The front wipers on your 1995 Pontiac TranSport minivan are intermittent because there is a manufacturing defect in how a couple of connections were made (soldered) to a control board that is located in the motor assembly. I had the same problems with a 1996 TranSport and the fix took only minutes once the motor assembly was removed. Basically, it involves resoldering a couple of connections. Other than a few hand tools required to get the assembly out from under the hood, only a soldering iron and some solder are required. There is a really good web site with a complete set of photos describing the fix once the box is out. http://james.jaguar.net/subtopics/WiperFix.htm The wipers on my Transport got worse and worse until they finally quit altogether. Some have suggested replacing the control board but a healthy dose of solder will cure the problem.
When I start my 1995 Pontiac Transport 3800 the heater fan and wipers do not work unless I turn the ignition key up.?
i would change the electrical part of your ignition switch- i would change the electrical part of your ignition switch-
