0
Who told you you have a bad "water seal"?
Are they referring to the plugs in the side of the engine block? If so, knock the out with a hammer and screwdriver. Use install tool to reseat the new ones.
If they are referring to a water pump, it is just unbolt old, clean connection, install new.
What else can I help you with?
Will a 1996 Chevy Suburban transmission work on a 1995 Chevy Suburban engine?
Yes it will, there the same.
Where is rollover switch 1996 Chevy Suburban?
Chevy did not use them on there trucks.
Does a 1996 Chevy Suburban have air condition filters?
No
Where is the coolant temperature sensor on a 1996 Chevy suburban?
To the left of the thermostat housing, It screews into the intake water jacket.
Will a 1997 Chevy Suburban rear end fit a 1996 Chevy Tahoe?
yes
Will a 1996 Chevy 4x4 Silverado transmission fit into a 1996 Chevy 4x4 Suburban?
Yes it will fit right in there. No problems.
Will a 1993 Chevy suburban trans fit in a 1996 gm suburban?
Yes it will if there both 4x4 Transmissions.
What type of car did biggie die in?
A green 1996 Chevy suburban
How many 12 subwoofers can fit in 1996 Chevy Suburban?
36
Wilwill the hood bumper grille and fenders off a 1993 Chevy Suburban work on a 1996 Chevy Suburban?
the hood and bumper and fenders will, the grille is slightly different
How much does it cost to paint a 1996 Chevy Suburban?
9 million dollars
How do you change the pittman arm on a 1996 Chevy Suburban?
You need a wedge tool to separate the arm from the main steering rod , then unfasten the two bolts and it is off .
