Alternator Removal & Installation 1. Disconnect the negative battery cable. 2. Rotate the drive belt tensioner away from the drive belt and remove the drive belt from the alternator pulley. 3. Detach the electrical harness connectors at the alternator assembly. 4. Disconnect the positive battery cable and remove the nut and washer. 5. Remove 2 front alternator bolts. 6. Remove the rear alternator support bracket retaining bolts and the support bracket. 7. Remove the alternator from the vehicle. To install: 8. Place the alternator in position and loosely install 2 front alternator retaining bolts. 9. Install the alternator bracket and 3 alternator bracket bolts. Tighten to 84 inch lbs. (10 Nm) 10. Tighten 2 front alternator retaining bolts to 19 ft. lbs. (26 Nm). 11. Connect 2 electrical hardness connectors to the alternator assembly. 12. Connect the positive battery cable and install the nut and washer. Tighten the nut to 72 inch lbs. (8 Nm). 13. Rotate the drive belt tensioner away from the drive belt and install the drive belt on the alternator pulley. 14. Connect the negative battery cable. 15. Start the engine and check for proper charging system operation.
By buying a Chilton or Haynes manual and reading
how to change alternator in acura 1999 cl
take off the screws
No, 98-02 have different mounting, you can use 91-96.
On the Vulcan engines the alternator was same from '98 to '03.
I believe the voltage regulator is in the back of the alternator
The voltage regulator is built into the alternator on all Contours, no matter what year or engine.
Passenger side : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Ford Expedition
Defective alternator, dead cell in battery, or something is on pulling power from the battery.
No, the fuse for the alternator on a 1998 Ford F-150 would not be a 25 amp. It would most likely be a 20 amp.?æ
How do you change transmission fluid in 98 zx2
14.7