0
To change the engine computer (ECM) on a 1988 Chevrolet Celebrity, first disconnect the negative battery terminal to ensure safety. Locate the ECM, typically found under the dashboard on the passenger side. Remove the mounting screws and unplug the wiring harness from the old ECM. Install the new ECM by reversing the process: connect the wiring harness, secure it with screws, and reconnect the battery.
What else can I help you with?
How do you change the fuel pump in a 1975 Chevrolet celebrity?
There was no 1975 Chevrolet Celebrity made. What year do you actually have and which engine does it have?
How do you find and change the water pump in a 1986 Chevrolet Celebrity?
what type of engine do you have?? V6
Where is the crankshaft position sensor on a 1987 Chevrolet celebrity?
The crankshaft position sensor on a 1987 Chevrolet Celebrity is on the side of the engine nearest the firewall. I need to know which engine to give a more specific answer.
Can you put a 2003 Chevrolet Malibu computer in a 2000 Chevrolet Malibu?
I doubt it very much as they change engine specs every year.
Where is the horn located on a 1987 Chevrolet Celebrity?
The horn is located in the engine compartment.
Where is water pump on a 1987 Chevrolet celebrity?
The water pump is on the front of the engine.
How to Change Engine Computer for 1988 Chevrolet s10 pickupwith a 2.5 liter Were is the location of the Engine Computer?
the computer is located under the glove box. You simply change the computer with another one with the same code. The whole job should take you less than 1/2 hour.
What happens when the module goes out on the 1988 Chevrolet celebrity?
What happens depends greatly on which module fails. If the engine control module (computer) fails it may cause the engine to run poorly or not at all. If the ignition module fails the engine won't start.
How do you find the water pump on a Chevy Celebrity?
Water pump location on a Chevrolet Celebrity varies both by the year and engine. I need to know the year and engine in your car to answer your question.
How do you change water pump in 1989 Celebrity 4.0L engine?
No Chevy Celebrity ever had a 4.0L engine
How do you change the water pump on a 85 Chevrolet celebrity 2.5L engine?
To change the water pump on a 1985 Chevrolet Celebrity with a 2.5L engine, first, disconnect the negative battery cable and drain the coolant from the radiator. Remove the serpentine belt, then detach the water pump by unbolting it from the engine block. Clean the mounting surface, apply a new gasket or silicone sealant as needed, and install the new pump. Finally, reassemble everything, refill the coolant, and reconnect the battery.
Where is the oxygen sensor on a 1988 Chevrolet celebrity?
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
