Remove the two torque type mounting screws from the headlamp and gently move the headlamp out of the way, Power cable to headlamp can be removed but not needed.
Easy access to fog lamp bulb is then achieved. Disconnect fog lamp power cable and twist bulb to remove.
open bonnet unscrew the screws to get at the bulb just use a bit of common sense it's not that hard!
reach up under front bumper and twist the bulb out.
According to the 2001 Ford Mustang Owner Guide : Tail lamp , Brake lamp , Turn lamp takes ( # 3157 K bulb )
Unscrew both screws on trim around light Then unscrew the light Remove bulb Change and then screw back in
Remove the two screws holding the lamp lens to the body. Pull lamp unit out ,1/4 turn on the lamp holder will remove the lamp unit . Replace the bulb and refit in the reverse order..
how do I replace a parking lamp (left) on a 1996 Ford Taurus
Pull the burned out bulb out of the end of the cable and push in a new #912 bulb. {At least this works on a 1993 F-150}
if it front lamp, pull out holder. if rear light bulb...remove rear lamp assembly, 1 screw on outside other is wing nut inside rear boot area.. very easy job to do.
All lamp/bulb numbers for the 2007 Ford Edge can be looked up in sources and related links below.
You can change a bulb in the multi function display unit of a 307 by first making sure that the lamp is turned off. Then unscrew the bulb and remove it from the lamp.
It is a double ended halogen bulb and I do not know how to get to it to release it from the lamp.
1984 Ford F-250 front turn signal light bulb lamp replacement: Purchase the correct replacement front turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the front turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).