Unfortunately, Honda parts usually require special tools. You will need a fork seal driver, which is pretty standard. But you will also need a special driver to remove the bolt at the bottom of the forks. This tool can be made, but it may be better to order the part.
Visit a Honda forum for specifics, since every bike is different. Changing fork seals is generally the same. Make sure to use a proper fork seal driver, since slight nicks to new seals can cause the seals to break.
In a nutshell: Remove the dust cover, then the clip that holds the seals in place. Pull the forks apart being careful that the spring doesn't force the top fork out too quickly. Drain the oil. The parts of the forks are held together with bolts at the bottom of the forks. That's what the special tool is for. Clean out the forks and return the parts. Pour clean fork oil, drive the seals in place. Replace the clip and dust covers. The amount of fork oil is important. Check the service manual or a Honda forum.
1999 Honda 750 Shadow reserve position is front.
what wheel will fit Honda vt 600 vlx shadow
it will explode
The Honda Shadow Spirit, recommends 29 psi in the front tire and 32-36 psi in the rear tire.
28 psi front, 36 rear.
2.0 bar front and back.
32 front, 36 rear.
There 1 screw on each side towards the bottom, take them out and the the front glass and ring will come out.
4 to 6 psi.
450 ml.
front = 3.50-18 rear = 130/90-16
It should be on the bottom just in front of the center stand.