answersLogoWhite

0

Drop the fuel tank.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Which relay is the starter relay on a 1994 Buick lesabre?

Which relay is the starter relay on a 1994 buick lesabre


Where is the fuel pump relay located on a 1994 Buick lesabre?

fuel pump relay location in 1994 buick lesabre


Where is the computer in a 1994 Buick lesabre?

On my 1994 Lesabre it is under the dash about center at edge of carpeting


How do you change the harmonic balancer in a 1994 buick lesabre?

I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.


What type of diagnostic code scanner is required for a 1994 Buick LeSabre?

94 buick lesabre was right at the change over( obd1 to obd2) some have an obd2 connection with an obd1 computer. this can only be read by buick garages. go to auto zone or checker auto and they can tell you.


How do you replace a rear wheel bearing on a 1994 Buick LeSabre?

I have a shimmy or small vibration while driving the interstate on my 1994 buick lesabre - if i was to check the front and rear bearings - how would i do that and what would i look for


FAQ10what would cause a 1994 Buick LeSabre v6 to shut off my self going down the road?

what would cause a 1994 Buick LeSabre v6 to turn off going down the road.


What cause humming in right front wheel of 1994 Buick LeSabre?

wheel bearings are going bad, need to change your hub assembly


What type of brake fluid do you use in a 1994 Buick LeSabre?

Dot 3


How to replace a serpentine belt on 1994 buick lesabre?

replace tension put it on


How do you replace a wheel bearing on a 1994 Buick LeSabre?

AnswerFront or rear?front


How do you repair the cruise control on a 1994 Buick Lesabre Limited?

First you need to troubleshoot the 1994 LeSabre cruise control. Check the fuse, the cruise switch, the linkage, to find where the problem is. Check the vacuum lines on the engine as a vacuum leak can cause the cruise to not work properly.