answersLogoWhite

0

config cli prompt "NAME"

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Which element does not need to be configured to support SSH connections to a router or switch?

A hostname


How do you install neutral safety switch on Honda passport?

No


Which names correctly identify the CLI mode represented by the prompt for Switch-East4?

line configuration mode user executive mode * global configuration mode privileged executive mode interface configuration mode * enable mode8 What command is used to change the default router name to Fontana? Router# name Fontana Router# hostname Fontana Router(config)# name Fontana * Router(config)# hostname Fontan


Ignition switch 1996 Honda passport is locked car will not start?

if the battery is dead the switch wont unlock or start


How do you replace the neutral safety switch on a 2000 Honda Passport?

The switch is bolted on the side of the transmission. Remove the bolts and the wiring connector to remove the switch for replacement.


Why no power to starter when you turn key on 1996 Honda Passport?

Check the park/neutral safety switch, or clutch switch if its a manual.


Why would the wipers on a 99 passport work on high and low but not on delay?

try checking the switch


How do you determine if the power window switch is bad on a 98 Honda passport?

To determine if the power window switch is bad on a 1998 Honda Passport, first check if the window operates with the switch from the driver's side and the individual door switches. If the window does not respond at all, test the switch by using a multimeter to check for continuity when the switch is pressed. Additionally, inspect the wiring and connections for any damage or corrosion. If the switch tests faulty but the wiring is intact, it likely needs to be replaced.


How do you remove the ignition switch from your 1998 Honda Passport?

To remove the ignition switch from a 1998 Honda Passport, first, disconnect the negative battery terminal to prevent electrical shorts. Then, remove the steering column cover by unscrewing the screws that hold it in place. Once the cover is off, locate the ignition switch assembly, disconnect the wiring harness, and remove the mounting screws to take out the ignition switch. Finally, carefully pull the switch out from its housing.


What is another word for alternative?

Change. switch


What is a speical switch used to change the britness of lights?

A "dimmer" switch will change the brightness of lights.


How do you change turn signal switch on a 1994 Firebird?

How to change blinker switch in a 1994 Firebird ?