To get to the relay, you'll have to remove the driver's side kick panel and go in from there. Here is a detailed DIY article with photos:
Fuel
where is locate the main relay on 1996 acura integra
There are a few possibilities for the problem. The most likely are the main relay and the engine temp sensor. The main relay is a problem very common to older Honda/Acura models, and the temp sensor is a common cause is general.
under the steering wheel i guess
To change the rear main seal on a 1993 Acura Vigor, first, you'll need to remove the transmission, which involves disconnecting the driveshaft and unbolting the transmission from the engine. Once the transmission is out of the way, you can access the rear main seal, which is located at the rear of the engine block. Carefully remove the old seal using a seal puller or a flat tool, clean the sealing surface, and then install the new seal, ensuring it's seated evenly. Finally, reassemble the transmission and all components in reverse order.
change your main relay
its probably the main relay that needs to be replaced
IgnitionSwitch
To change the rear main seal on your 1993 Acura Vigor, you'll first need to remove the transmission to access the seal. Start by disconnecting the battery, draining the transmission fluid, and removing any components blocking access to the transmission, such as the exhaust or driveshaft. Once the transmission is out, remove the old rear main seal using a seal puller or a similar tool, clean the area, and install the new seal. Finally, reassemble everything in reverse order, ensuring all connections are secure and fluids are topped off.
Under the steering wheel, under the dash to the left.
Under the dashboard above the brake pedal.
The Main Relay on a legend in under the dash board. Alittle hard to get to and a quick fix at a acura dealership. If your having starting issues, it's your problem.