answersLogoWhite

0


Best Answer

plug is located under plastic cowl in front of engine must remove cowl 1st than you will see plug. you can drain oil from dipstick with pump also availible at jcwhitney.com works great

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change oil in a 2000 Passat----4 cylinder you can't seem to find where to drain the oil?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the drain bolt 2000 Honda Accord 4 cylinder?

The oil drain plug is located on the bottom of the engine screwed into the oil pan.


Where is the oil drain plug on a 2000 Ford Ranger 2.5 4 cylinder?

The oil drain plug on the 2000 Ford Ranger is on the rear of the oil pan. It is located under the vehicle near the center.


How to change Transmission oil 2000 yz250?

THERES A DRAIN BOLT ON THE BOTTOM OF BIKE, DRAIN THEN FILL WITH 750 ML


How do you change coolant in a 2000 Dodge Dakota Quad 4x4?

Drain the radiator


Change the oil on 2000 Mercedes ML350?

i can't find de drain


Does 2000 Toyota Camry have cylinder oil drain holes?

Of course, it does. You can find it just in the middle of the engine oil pan.


Do you need to drain oil to change oil sending unit in 2000 chevy cavalier?

No you do not.


How do you Change a timing belt on 2000 GRAND AM 4-cylinder?

It does not have a belt, it has a chain.


No drain plug for rear differential on 2000 sonoma?

That's right, no drain plug back there. To change the lube you need to remove the diff cover.


How do you change the oil in your 2000 Chevy S-10 Blazer?

drain oil,change filter,refill- or go to speedy lube


Where is the engine block coolant drain plug located on 2000 Chevy s10 four cylinder?

Rear of the engine block, near the oil pan.


How do you replace cylinder pack on a 2000 Chrysler Town and Country van transmission 3.3 motor?

You can change the cylinder in your 2000 Chrysler Town n County by removing the head. Remove rod bolts from the crank. Push the cylinder out. Reverse the process to install the new cylinder.