Place a drain pan underneath the radiator and drain the radiator into the pan when the engine is cool. Disconnect the negative battery cable and remove the drive belt, timing belt and disconnect the lower radiator hose. Remove the bolts that hold the water pump and take it off. Install the new pump, replace the belts, and reconnect the lower radiator hose. Fill the radiator with antifreeze.
if its like the 96 its not 2 hard. breather cover. if im not mistaken theres 6 bolts & a few hoses. the bottom r/h mount bolt is a pain 2 get off for 1st timers tho. make sure u have something to catch the fluids.
Drain all the water off,air filter box off, engine mounting off, undo all the bolts on the pump,remove all inlet and outlet hoses.
Reassembly replace with new gaskets and hose clips and tighten pump bolts,replace engine mounting+ air filter box, refill water with antifreeze, done
If you are not A pretty decent mechanic, Don't try this job! Its not an easy job like on A V-8.
how
To change water pump on a 1995 Blazer, disconnect theÊnegative battery terminal. Empty the coolant and unfasten the water pump. Replace with aÊnew one. Ê
== ==
No , a 1994 Mercury Cougar is rear wheel drive
A 1994 Mercury Cougar is OBD I , EEC - IV ( there should be an EEC TEST connection in the engine compartment )
A 1994 Mercury Cougar is ( OBD I , EEC IV ) There should be an EEC TEST connection in the engine compartment
if your 94 cougar has the 4.6 v8 u can only use the trans from a 94 or 95 cougar or thunderbird with the 4.6 v8
ok
What is the motor size? Run1
MAP Sensor on a 1994 Cougar is located on the firewall. Has a vacuum hose coming from it and an electrical connection.
Check inside the center console.
What is the motor size? Run1
5x7 or 6x8, either or
Remove the tire and wheel from your 1994 Mercury Cougar. Remove the brake spring and brake caliper. The brake shoes will come off.
1994 Ford Thunderbird 3.8L V6