im colin in lincs , on the clio exhaust rear box there is a 3 bolt mounting , on the left hand side of the exhaust box , also before you can remove it , there is a small bolt in the cetre of the mount where it slides onto in the centre of the mounting , about 8 or 9 mm i think , then it just slides off , refitting is a reversal of dismantleing , good luck ,, colin
You have to remove the air conditioning compressor bolts set the unit aside but do not remove the freeon hose. Then remove the mounting bracket and then you can get to the bypass hose to replace it. Replace mounting bracket and compressor and job is complete
if you need to ask a dumb question like that then u really shouldnt be messing with a car... you will kill someone, take it a exhaust centre
You remove the caliper only to replace pads, and then caliper mounting bracket to replace rotor.
Yes....In fact, any 87-96 (maybe later even) coil packs from a 2.8, 3.1, 3.4, 3100 SFI etc will interchange. The only thing that changes is the mounting location and bracket. The 3100 moved the pack to the top of the engine and had to change the mounting bracket. But the ICM and coils can be removed and put on your original bracket.
Remove mounting bracket Remove hose clamps Remove filter and replace observe flow arrows on new filter
how do you change a dashboard bulb in a renault clio?
how to change Renault megane timing belt
None, just two bolts. One for the shield and one for the mounting bracket.
To change the brake rotors on a 1991 Honda Civic raise the vehicle. Remove the wheels and brake caliper bracket. Remove the brake pads. Loosen the rotor mounting screws and replace the rotors.
Locate the horn behind the front bumper on the driver's side.. Unplug the electrical connector to the horn. Remove the horn mounting bracket bolt. Remove the horn.
This largely depends upon the condition of the mounting studs. If they are clean, it's easy; if they are bad enough, they might require cutting off and new studs.
Look under the exhaust manifold on the side of the motor facing the radiator. You have to drop the manifold and the oil filter bracket to change it.