drop your gadget from the 3rd floor of a building and poof you got it.
Go to G20.net and ye shall find ;)
Use a breaker bar or rachet to move tensioner out of the way
the infiniti g20 does not use a belt,it uses a timing chain that does not need maintenance
I can't find the starter a 1996 Infinity G20?
This is an easy one. There is a belt tensioner on the top of the engine which applies tension to the serpentine belt. A small wheel rides above the belt and applies the tension. Put a ratchet and socket on the bolt found in the center of the small wheel. The wheel and arm it is attached to will move up as you apply pressure to the ratchet. It is only necessary to move the small wheel and arm a short distance in order to slip the serpentine belt from under it.The trick will be replacing the belt. If the label showing the routing of the serpentine belt is missing (usually on the air intake pipe) draw a diagram before removing the belt.
Find the belt tensioner and using a socket and ratchet move the tensioner wheel and arm upwards just enough to slip the belt out from under the tensioner wheel. Make note of routing pattern for old belt so new belt can be installed exactly the same.
Check out G20.net
serpentine belt routingIt is usually marked on the radiator shroud and shows a diagram if not there check another vehicle with the serpentine belt diagram or go to you local library and ask to check a chilton manual on Chevy 305/350 Wayne Also, a good online resource with schematics is the AutoZone website.
do you have avideo
how to remove a water pump on a 95 infiniti g20
I believe '91-'94 are compatible.
This is an easy one. There is a belt tensioner on the How_do_you_change_a_serpentine_belt_on_a_1992_Chevrolet_G20_vanof the engine which applies tension to the serpentine belt. A small wheel rides above the belt and applies the tension. Put a ratchet and socket on the bolt found in the center of the small wheel. The wheel and arm it is attached to will move up as you apply pressure to the ratchet. It is only necessary to move the small wheel and arm a short distance in order to slip the serpentine belt from under it.The trick will be replacing the belt. If the label showing the routing of the serpentine belt is missing (usually on the air intake pipe) draw a diagram before removing the belt.