loosen track, tip machine enough to remove screw on one side front of slider, use a screwdriver/hammer to move the slider towards the back of the machine and through a track cog hole, may have to slightly pry it through to start, keep moving it back until out, measure old to new after removal, cut new to same size and tap through the same hole until screw hole lines up in front, put screw in. tip machine on other side and repeat. I took and used the small piece I cut to make slider the correct size as a sacrificial stiking device so as to not dammage the new slider. after second one is on, tighten track back up to spec and allign and good to go. Probably one hour from start to finish.
97% as a fraction is 97/100
what steps do i take to change a timing belt for a '97 mitsubishi mirage
I don't think the 97 has a distriburetor.
today I change my own in my 97 sebring, I will let you know when I finish how it went
how to change a valve cover gasket on a 97 mercury grand marquis ?
97/100
97/63 = 1.54 (rounded), so 63 increased by 154 percent equals 97.
how to change fuel filter on a97 grand am
mine is a 97 and it will go 85 mph
Change the belt
look up kitwood 97
how to replace that