Want this question answered?
I have a Kawasaki KTR27A string trimmer and I am very disappointed that Kawasaki's Owner's Manual did not include instructions on how to put new string in their trimmer. The challenge was getting the spool out. I finally figured out that you need to depress the center bumper and turn it clockwise. It will move easily to a stop, then turn it just a little harder and you will feel it move a little more. That releases it and you can pull it straight out. Then, just wrap new string on (direction is indicated on the spool), feed the two ends out through the holes in the head, and put the spool back in making sure not to have any of the new string underneath the spool. Then depress the bumper and turn in counter-clockwise to set it in place.
One String at a Time!
you don't change yyour American girls head you can if you take the string that's attached to her head untie it and then lift it out of her body put it back in by slipping it innto the hole then tying the string
you stick your hand into the dangerous part of the bike. then punch yourself in the face
pull straight out to remove the spool, wind in the direction of the arrow - to replace, feed the string through the hole and pull on it, keeping slight tension on the spool as you push it back into the head
His clothes got covered in blood from Crona, but I think that the artists were just tired of that fat jacket that he had.
any time you change, remove, or tamper the strings it will change how the head will throw. depending on how your other shooting strings are set it will either create more whip or take some off. but yes you can take the U string off
I have an Echo Straight Shaft Weed Eater 2cycl 21.2cc. I am having trouble restringing it! The instructions show to line up the head with the arrows which i did then to push one end through one end out the other! One of the problems is the String doesn't want to come out the other end! With Needle Nose Pliers I was able to get the other end out. then i pulled it out making both end equal. then it says to hold the head and turn clock wise the top part of the head! The problem is it will not wind up the line? I tried it and started all over again by pulling the line out and restringing it again still it won't pull the string into the head! What am i doing wrong? What do I need to do? This is suppose to be easy! But I can't seem to get it! I am frustrated and not able to use my weedeater! Thank you for your Help Sincerely robert
The Kawasaki 110 cylinder head bolt torque specification is 120 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
your head gasket it blowen
12
The head gasket bolts, on a 3010 Kawasaki motorcycle, should be torqued at 35 pounds per square inch. They should be torqued in 10 pound intervals.