i would like to know where the pvc valve is and how to change it on my 1990 olds 98 regency 3.8.
where is the pvc valve located on a 1980 olds cutlass 3.8 v-6
Standing in front of the engine, its on the left side of the engine intake. You'll have to remove that MAP sensor to get to the PCV Valve.
Engine Size? Anyways, look on one of the valve covers, I believe you will find it there.
In the intake behind the throtle body.
change the (pvc) valve
The 1992 Oldsmobile IAC valve can be found attached to the firewall in the engine compartment. The valve will be on the passenger side of the firewall.
There isn't one on that engine. Only a crankshaft sensor at the back of the engine.
folow your top radiator hose to the engine that is where the thermo stat will be at you will probly have to remove your air cleaner and throttle body to get at the thermostat housing
Under the car on the drivers side front of the engine
the block,heads and valve covers were a dark forest like green
This depends 100% on what engine it is.
In the tire. It is the valve stem.
what year and type of olds engine??
It's on the front valve cover of the engine, it just pushes into a rubber grommet and there is a hose coming off of it.
remove engine cover. locate AIR MASS unit ( unit where fuel enters your engine-- -drivers side where air also flows into engine) the EGR valve is located right in front of AIR MASS unit. good luck
engine has to be raise of lowed or sometimes removeing the engine. it better to take to shop.
wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine
Not knowing what engine you have in your Olds, most engines will have the "Mapping" of the belt located somewhere under the hood. On my two Olds, they are located on the valve cover. When you purchase a new belt for your car the cardboard holder for the belt will display several diagrams based upon the engine that the belt will fit..... you out.
"Remove this only when cold (caution injury & vehicle damage" It is under your engine intake manifold plenum (the to metal assembly on the engine) almost center of the valve cover on the rear bank (closest to the fire wall). To change this you must rock the engine forward. You may need be able to remove this w/out removing the intake manifold. If you do be very carefull of the spider web thin vacuum lines under the manifold. If you remove the intake manifold you may need to purchase the intake manifold and any other gaskets and seals.
You don't, as it has no belt. It has a chain that should last the lifetime of the engine.
If the 1998 Olds Achieva will not rev over 2500 rpm there may be an issue with the idle control valve. A bad or unplugged valve will not let the car accelerate over 2500 RPM.
To bleed the cooling system on a 1996 Olds Cutlass, locate the bleed valve, which is on the front of the engine above the water pump. After making sure the cooling system is not under pressure, open the valve by turning it counterclockwise. Fill the radiator with coolant until no air comes out the bleed valve, and a stream of coolant begins to flow from there instead. Tighten the valve and close the system to finish the job.
Yes, in the transmission.