answersLogoWhite

0


Best Answer

This one's a snap... well, about 4 snaps... At the unit that houses the filter, there are 4 snaps that hold the case together. Simply raise them up - one at a time - until the top comes off... From that point, replace the filter and reverse the process to put it back.

If you've not done this in awhile, you won't BELIEVE how dirty the old one is!

Tom Pay It Forward

User Avatar

Wiki User

โˆ™ 2015-07-15 21:37:46
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the air filter on a 2003 Chrysler Sebring?
Write your answer...
Submit
Related questions

Do a 2003 Chrysler sebring lx have a oil filter?

yes


Where is the cabin air filter in a 2003 Chrysler Sebring?

It doesn't have one.


Does a 2003 Chrysler Sebring have a cabin filter?

No.No.


Does a 2003 Chrysler Sebring have a cabin air filter?

No, it does not.No, it does not.


How many quarts of transmission fluid does it take when you change the transmission filter on a 2003 Chrysler sebring sedan f?

You will need about five quarts.


When to change the timing belt on a 2003 Chrysler Sebring?

Replace it every 100,000 miles.


Where can you find the choke heat sensor on a 2003 Chrysler sebring 4-cylinder coupe?

A 2003 Chrysler Sebring is fuel injected and does not have a choke.


Where is the fuel filter located on a 2003 Chrysler Sebring?

There is a filter located at the lest rear of the fuel tank


Where do you find 2003 Chrysler sebring lx owners manual?

The owners manual for a 2003 Chrysler Sebring LX is found at an automotive shop. It can be found and purchased from the dealership as well.


Where is the oil filter located on a 2003 Chrysler Sebring?

It is located at the passenger side behind the oil pan. You need to be under the vehicle to watch it .


What grade of oil does a 2003 Chrysler Sebring need?

5w30


Does a 2003 Chrysler Sebring have anti-siphoning gas tank?

Yes


What is the transmission fluid capacity for a fluid and filter change in a 2003 Chrysler town and country?

Fluid needed after filter change is normally about five quarts.


How do you replace a water pump on a 2003 Chrysler Sebring six cylinder?

When you change the water pump on 2003 Chrysler Sebring six cylinder, you first need to purchase the correct replacement pump. You will need the right tools including wrenches to remove the old pump that is located on the cylinder block in the engine.


What is the oil capacity for a 2003 Chrysler sebring sedan 2.7L?

5 quarts


Can you use r134a on a 2003 Chrysler Sebring convertible?

Yes, that is the proper refrigerant.


When should you replace the timing belt on a 2003 Chrysler Sebring?

100,000 miles


How do you change air filter on a 2004 sebring coupe 2.4lt engine?

if its the same as the 2003 i unscrewed the whole housing for the air filter then took it off. because i couldn't get the filter out with out doing so.


Find a spark plug location for a 2003 Chrysler Sebring?

Middle of the valve covers.


Does a 2003 Chrysler Sebring have a timing chain?

2.7L is a chain. All others are a belt.


How do you add transmission fluid to a 2003 Chrysler Sebring?

You pour it down the dipstick tube.


Name of electronic box on front of transmission Chrysler sebring 2003?

Solenoid pack


Does a 2003 Chrysler sebring convertible have rear ball joints on the front and the back?

Yes


What type of oil does a 2003 Chrysler Sebring lxi convertible need?

It uses 5W30 conventional.


Is the 2003 Chrysler Sebring all wheel drive?

No, only available in front wheel drive.

Study guides

๐Ÿ““
Create a Study Guide