0
Ballasts can be quite different even if you order a replacement part for a specific fixture. You need to follow the wiring diagram on the new ballast. If this is confusing or not easy to follow, you need a competent electrician to do this for you.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Is a ballist use on a hid light?
Yes, HID lights need a ballast.
What is wrong with my fluorescent fixture?
First make sure the bulbs aren't blown. If that's not it then you want to make sure the fixture is getting power. If it's getting electric to the fixture then the ballist is bad. ( IF YOU DON'T KNOW HOW TO CHECK THESE THINGS, PLEASE CONTACT AN EXPERIENCED ELECTRICAIN!) hope this will help.
How do you change the high mount brake light bulb on 2004 Honda Pilot?
Hi, I just changed the whole fixture for the third light. There are two caps on each side of the fixture. With flat screw driver, take off the caps and take out the screws. The light fixture will come out and twist the socket of the light bulb. Now you can able to change the light bulb. I hope this will help you all.
Is a light bulb considered a fixture?
A fixture is what the light bulb goes into.
How do you change the rear brake lights on a 1988 Chevrolet Celebrity?
To change the tail light bulb on a 1986 to 1989 Chevy Celebrity coupe or sedan: 1. In the trunk by the appropriate quarter panel there are three nuts, the middle nut holds the outer end of the tail light fixture in place. Remove that nut, it should align with the middle of the tail light fixture. 2. Pull back on the tail light fixture until the stud comes out of the body. Then pull slightly outward on the tail light fixture to pull a tab out of the backup light fixture. 3. Locate the appropriate socket for the bulb you are going to replace and remove the socket from the tail light fixture. Put in the new bulb and reverse the instructions to put the tail light fixture back in place.
How do you remove the tail light lens from a 1989 Chevy Celebrity?
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture: 1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture. 2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture. 3. You can now take the appropriate socket out and replace the bulb. Reverse the steps to replace the light fixture.
How do you spell fancy light fixture?
The correct spelling for a fancy light fixture is "chandelier."
How do you change the tag light on a 1998 Crown Victoria?
Very easy to do. Remove the two cap screws from the lens fixture (uses a 6mm socket, I believe). Very carefully use a flat tip screwdriver to gently pry the fixture from the underneath side of the trunk lid, and it should hang down with the light fixture attached to it. The fixture is made of a rubber-like plastic, so gently working it side to side will free it from the lens fixture. Remove the bulb from the light fixture by pulling it straight out (looks like an ancient camera bulb). You could use a 161 or 168 light bulb, but I used a 194 bulb (costs a little over $2.00 at O'Reillys) to reinstall into the light fixture. Going in reverse method, place the light fixture into lens fixture, and reassemble the lens fixture back to the trunk lid. Piece of cake!
How do you get at the tail lights on a '89 Celebrity?
To change the tail light bulbs in a 1989 Celebrity sedan: 1. Inside the trunk near the quarter panel are 3 nuts. Remove the middle nut, it should be in the center of the tail light fixture. 2. Pull back on the tail light fixture so the stud clears the body. 3. Pull outward on the tail light fixture to clear a tab out of the backup light assembly. 4. Twist the appropriate socket counter clockwise to remove the socket from the tail light assembly. 5. Change the bulb and put the socket back in the tail light fixture. Reverse the removal process to reinstall the tail light fixture onto the car.
How do you change a headlight on 2004 vw new beatle?
Look on the side of the light fixture under the hood of your car. There is a knob sticking out of the side of the fixture. Take a long screw driver and push the knob over about 1.5 inches. This will release the light fixture. Pull the fixture out from the front of the car and you can access the blubs. Don't forget to NOT touch the new light bulb - body oils will greatly shorten the life expetency of a halogen light bulb. anybody know how to change the cabin air filter in the same car? HELP!!!
How do you wire a 220 volts light?
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
How do you remove the dome from a light fixture?
Take the nut off at the bottom of the light fixture by unscrewing it.
