Remove the bolts holding the passenger side cross brace. Then there is a bolt on the right side of battery, take it out. Take the battery up from the back (towards the rear of car) and pull. Its heavy and a tight fit. Of course you needed to disconect the battery cables first.
For more room you can unbolt and remove the radiator overflow container and unbolt the front fuse block and shift it backwards. Hope this helps. "G"
To remove the old battery 1. Disconnect the negative battery terminal. 2. Disconnect the positive battery terminal. 3. Remove the crossbar support over the battery. 4. Loosen the washer bottle fill tube and move aside. 5. Loosen the fuse block and move out of the way. 5. Turn the battery sideways and remove. To Install new battery 1 Reverse the procedures bove.
Take out the old one, buy a new one, and put it in the SAME place.
there's no such thing as a 2007 rsx
The fuse for the left and right headlights on the rsx are found in the fusebox under the hood. It is on the driver side above the battery, in the black fuse box. The cover of the fuse box will tell you exactly where the fuse is.
To change the battery in the 2003 Cadillac Seville, you will need to first access the battery that is located under the rear passenger seat. Then remove the battery cables and remove the battery.
take off the power wire from the battery.
4 quarts to change the engine oil 5.4 quarts in an RSX-S with an oil filter change
The 2002 Acura RSX does not have a fuel filter
The transmission dipstick on a 2003 RSX is located toward the back of the motor on the driver's side. It usually has a bright colored handle, so that it can be easily seen.
The price for a replacement windshield for a 2003 Acura RSX varies depending on the region. A typical price ranges from about 200 dollars to 400 dollars.
Disconnect the Battery for 5 minutes
2.11337 qt
Disconnect the negative battery cable and then remove the positive cableRemove the battery heat shieldRemove the battery hold-down clamp boltLift out battery
Check fuses as the battery change should not initiate a "No Start" condition.